Motion Outdoor Lights Mains Powered - PIR Lights Outdoor - Bulkhead Wall Lights with Motion Sensor - IP44 Rated Security Lights - White Finish - E27 LED Compatible

great shed light for the garden. settings need playing around with to get it right but works great.

Does the job well, a little tricky to open and close though.

I already have one on the back of my house, and decided to install one on the front, very easy to install and has a light bulb fitting, not LED light, I have found sometimes the LED lights can be a problem! These lights have a bright light, and look great.

So far, good PIR outdoor light with very good range. I have it set for maximum sensitivity, which is giving me more than 10 metres. Also has a time and Lux setting. Used a E27/ES LED cool white LED bulb. Fitting not too bad, although the push in connector is not suitable for multi core cable. In my case I used 6242Y cable which is solid copper core, so this worked well. If needed the push connector can be replaced by a screw type terminal connector. Ensure that all holes for screws and cable are well sealed to prevent water ingress. Overall, good quality PIR light at a good price.

The sensor is a bit unpredictable sometimes it doesn’t switch on. It’s only been up for a few months and it’s really acting up not happy at all aside from that. It’s very easy to install and I’d say the brightness is good. It is quite cheap and nasty though.

Nice look overall. Had to unscrew the reflector to fully access one of the mounting holes. Cable connector simple and effective (but I had to unscrew the earth to fully wire the mains cable. Plastic cover a bit fiddly, so one of the closing tabs now snapped off. Instructions and operation both good.

Colour matches the UPVC frames of windows and doors Easy to fit and works on sensor for security

Having returned a light 3 times as expensive this one does everything I was hoping for. A little tricky to remove the lid but a broad blade or knife and gentle persuasion does the trick. You need to remove the connection shield to remove the connector block off its posts but then press the Lever down to insert the wire and release, no need for a screwdriver which I thought was useful. The sensor controls are easily adjusted and not as flimsy as other I have seen and the sensor swivels to allow some adjustment and tuning. Not claimed to be waterproof so I may put a bead of clear silicon around the lens but for the price that something I wouldn't complain about.