Carbhub Carburetor for Stihl MS210 MS230 MS250 021 023 025 Chainsaw Carb

Great carb

Great value for the money and fast start time and great compatibility and easy adjustment and perfect fit

Great value purchase

So far it works fine. Had to adjust the low side a bit lower. But as of day 2 my saw stihl ms250 saw still works. Only thing I might add is where the throttle link attaches on left side of carb is a little short. It needs to stick out a little bit further from the carburetor. On another note, when people order a carburetor online you should first remove old one and compare it to all the images on website making sure all the holes and such are exactly the same as in images online.

Fit my Ms250 perfectly. Very easy to install. Saw started on second pull after installing. Very quickly made minor adjustments to high and low speed jets and my saw ran as good as new!

Works great on my MS250. Starts immediately. I’d replaced the cylinder in my saw then the carb needed replacing bc it was hard to start despite Stihl’s reputation for easy start. This saw is about 15 years old. I never used non-ethanol. The thin diagrams may have just given out. This slid right on. Linkages were fine. Adjustment screws do not line up but I’m not sure why people make a big deal over that. It’s not like you adjust it every time - set them and be done. Besides, it’s not hard to take a cover off, right? The air cleaner fit just fine too. Comes w a plug and other lines, filters, gaskets, etc which I’ll save in case I need them later. You may need to get it started then hold throttle to get it tuned correctly. I don’t know that the number of turns from bottomed out are the same as Stihl but there’s only a slight amount of adjustment so you’ll find the sweet spot easily.

Have a Stihl 025 that I bought in the ‘90’s. Took it into an authorized dealer about 15 years ago, they said it needed a new carb and the didn’t make it anymore. Had to buy new, but lower power low profile. Found this on Amazon and it worked right out of the box. High end needs a little adjustment but I am extremely impressed that I was able to salvage such a high performance chainsaw.

nice kit got my chainsaw going again

Funciono 4 días y de ahi empezó a afallar

Fit perfectly for my OS23 STIHL chainsaw. No need to make any screw adjustments worked perfect out of box. Idle, high speed, etc … all excellent. Only comment is the supplied fuel filter is a bit smaller end hose connection but I just used a spring hose clamp on end so it worked fine. Excellent value !!

worked good until a tree smashed the saw into bits. RIP!

Fit my chainsaw and works great.

Replaced carb on a MS 250 and saw runs well. You will need to tune it to make saw run properly. You may have issues with fitment of rubber guard on saw that supposed to fit over idle screw ports.