Kit de reparación de embarcaciones inflables, 4 X PVC Patch, 2 X 30g Glue

Used on the bottom of my dingy, it's still there 6 months later, baking in the sun, no leaks. I'd use again.

Rien a dire

This kit worked perfectly on two holes that were both roughly 12mm in diameter in my inflatable boat. Cleaning the area to be glued with acetone (not supplied) is 100% essential, I also cleaned the patches supplied with the kit beforehand too. Apply a covering of the glue to both the area around the hole and the supplied patch, then wait 5 minutes before applying a second coating to each once more. 5 minutes after the second coat I then applied the patch over the hole, rubbing the two together with a blunt wooden straight edge. I then left the glue to cure for 48hrs before inflating the RIB (HD Quicksilver 3.5m) and it has held beautiful under load on rough seas. I recommend this product 👌 but acetone must be used pre-gluing in my opinion. I hope this helps 🙏

The butyl rubber that makes most kayaks and SUP's is not thin nor cheap so why buy a cheap thin rubber kit? I bought a used 2 place kayak, it wasn't cheap and it's designed for ocean use as well so the rubber is much thicker and can take a few runs across sharp rocks before it will puncture. So...when it came time to order a patch kit, I wasn't about to go cheap nor should you. The rubber patches are quite thick and the glue is also not a tire patch glue, it's designed for this specific application and I got 2 tubes within this tube. Not sure why but there is not carabiner hole or lanyard attached nor is there a place to do so, that was the only odd part about this. Overall the storage container isn't water tight, more water resistant so I've placed this is my waterbag when I go out kayaking. I'm happy with this decision and purchase, the right tool for the right need.

La colle marche très bien et on a le choix des couleurs