1/4 Inch Compressed Air Pressure Regulator Water Trap for air Compressor Air with Pressure Gauge Oil Separator Pressure Regulator Compressor Water Trap

Works perfectly for an in-line filter lift and set the pressure and then lock it in a great and needed filter all in one

Works well, very happy

Fantastic bit of kit, well made and works well !

Good fitted to my small compressor and working well

The thread on the connector sheared off while being tightened with a hand tool leading to an expensive repair and lots of valuable wasted time. Not happy at all.

Having spent my entire life working in the commercial diving industry, I am extremely familiar with compressed air and high pressure gas and their component parts. Given this, this item turned up today to use on my new compressor. It came in component form but there was no literature, with it, detailing how to put it together or how it operated, nothing at all. Without any background in working with compressed air, which I fortunately have, I would imaging that there would be a few people, out there, who would have problems. I figured it out and found out how the regulator worked (least I think I have) given in factory settings, nothing comes out of it. As to assembly, again in my case, I could see how it went together and found the 'difficult to see' flow direction. The fitting (I think) are BSP (parallel thread) supplied is some cheap PTFE tape but given the the fitting is brass (at least it looks like it) and the filter body is aluminium you have to use a large amount of PTFE tape, which you shouldn't do - the tape is to lubricate the thread not seal it. I also ended up using 'O' rings to achieve a seal. In the package there is, listed, 2 brass fittings, I have no idea what they are for and without any book of words they sit on the bench, unused. Its possible that they are a 6.0mm self locking female but what the hex is on the opposite side of the fitting, I have no idea. I have given this 2 stars as I think it works but have nothing to refer to, to confirm I have it right.

Did the job for a good price

Not used yet but looks great and fitted my existing equipment. The only downside is the gauge would be perfect if it was in psi not kgm2

best goed ,,, en GEEN LEKKEN zoals sommigen hier neerschrijven ! gebruik teflon tape om perslucht lekken te voorkomen ***+++++10

Todo bien

Aucun problème. Se monte facilement.

Super, reduktor jest mały co pozwala wpiąć go do kompresora bez używania przedłużek. Regulator ciśnienia działa dobrze.

Alles na verwachting, Perfect!