Precision V2 Scope Rings with Weaver Anti-Recoil Lugs | Available in 30 mm or 34 mm Diameter

First set of this brand that I have purchased. If my example is any indication, these rings appear to be very good quality, have "Torx" style fasteners, and are a very good bargain compared to the more expensive "name" brand rings. Very happy with the 30mm, .850 height set that I purchased. Addendum 3/27/23: (Applicable to the "WEAVER" style rings only!) Regarding these rings, be advised that the integral "key" in the bottom of the ring, where it clamps to the Weaver style rail, is not sufficient in width to properly engage the rail so that it provides a recoil stop. This integral "key" needs to be wider in order to properly engage the slots on the rail. If using the rings that are designed for PICATINNY style rails, these should be OK. Again, if using the rings designed for the WEAVER style rail, be advised not to use them if a positive "recoil stop" to prevent movement of the rings/optics is desired.

Used the low Weaver rings on my son's Henry Mini Bolt. They are wide and have 3 set screws on each side. I mainly wanted to share some info I had to reach out to Monstrum for. The torque settings were not in the manual but they are 18 lbs for the rings and 20-25 for the screws to mount it to the Weaver/Pic rail. Hope this helps.

I purchased these for a 22 that needed a better scope which I had already from another gun. I always use my wheeler scope lapping tools to lap the rings from now on because in the past i bent a tube on a expensive scope with cheap rings so from now on they all get lapped first. With these i was really surprised on how well they were lined up. There was very little offset and they cleaned up near perfect with just a little lapping to be so cheap money wise. Every ring set no matter the cost gets lapped.

Put these on my Vortex Venom today... The scope slid several inches inside the rings and scratched the scope up. After losing the screws and looking at the rings, I noticed the top and bottom don't match up. (See 3rd pic) Then I took them off the weaver mount and saw that the "notch" inside the mounting bracket wasn't even wide enough to fit the weaver mount and it destroyed the edges so its completely useless after 1 box of ammo. It was 90% on the corners, and now they are shaved off to 45%. (See pics 1 & 2) Don't waste your time. These rings are cheap and poorly made.

Pr

Much better than CV Life junk. I bought CVLife scopes and regret it. The biggest one never worked but I didn’t check it until to return period expired. CVLife sent a bs letter. We would like to clarify that the elevation adjustment range for this scope is ±25 MOA, which should typically provide sufficient adjustment. In normal use, there is generally no need to adjust to the most extreme position. We recommend using the mounting bases included with our product for proper setup and adjustment. Please note that when the adjustment reaches its extreme limit, the internal spring is fully compressed, and the mirror assembly and reticle are pushed to their maximum position. This can result in slight image distortion, which is normal in such cases. We kindly suggest trying the adjustment again as per our recommendations. If the issue persists, please feel free to contact us, and we will do our best to assist you further.

anyone looking for 34mm rings know they dont come cheap, but i can say these are working just fine and stand up to the recoil of my 270 just fine

100% fits on the weavers rail like the description says and it fits great on Howa 1500 model warning only fits on weavers rails only and only 30mm tube from my order.