10-Inch 6T PCD Tip Hardie Fiber Cement Saw Blade with 5/8-Inch DMK Arbor, Polycrystalline Diamond Tipped Teeth Saw Blade for Laminate Flooring

I'm siding a new garage. This blade worked perfectly, first to last cut and at half the price of the better known brands.

Fantastic blade. Cuts fiberboard cleanly and has been holding up well to the remodel work. Prefer this over fiber shears as the cut is cleaner.

Why did you pick this product vs others?:I used this in my chop saw to cut Hardie Siding for my 1000 SQ foot house. After I finished the blade looks to still have a lot of life left in. The cuts were clean and quick and the dust was much less than I expected. I bought a smaller one for my Skilsaw too. Together they made the job go well.

Cuts hardie board nicely, make sure to cut on back side as blade rotation rears up edge a little, cut from backside eliminates tearing

Used this saw blade today. It cut very well. I only needed to cut 6 Hardie Cement boards to length and width so not a lot of use but the blade performed very well. Cuts were smooth.

Cuts well as advertised. Does make a lot of dust but that is to be expected. Use a mask and safety glasses. I installed on a dewalt compound miter saw and worked great.

A must have for long hardwood cuts and direct drive table saws or thick cuts. Other saws with large number of teeth will choke down where this blade will cut through.

Bought 2 of these and both had the same issue with the teeth weld. Both lasted about 200 cuts and the weld gave way on a tooth. Not cool. So don't waste your time because the quality is very low. It doesn't matter how little the blade cost because it is not a good value. After the tooth broke, the blade lost performance immediately and started by fraying the edges of the cut. Save your money and buy another blade.