KYMAR Noseless Replacement Foam for DJI Goggles 2/integra, black

I bought these for my Skyzone Cobra X V4 goggles and they work great, but had to modify them to fit properly...

I Like the foam and it feels a heck of a lot better than others. However, there are two versions of this. With and without a foam nose bridge. The lack of nose bridge for me did not work and i wound up going with the version that had the nose bridge connected. It is really a matter of feel though. With these you almost have to order both and see which one works for you. The design itself though feels the best and I am really happy.

These are a denser, thicker foam than the ones with the nose bridge that this seller sells. These appear to be the same as the ones NewBeeDrone sells. Good quality, good fit.

The title says it all, however I will say that with this installed I flew my Avata for almost 10 minutes and was in zero pain at the end. I can't say that when I use the stock surround. I look forward to more flying in my near future!

I got thesebfor a get of integra goggles. This is just a piece of foam weather striping with velcro adhesive tape on the back. I could have done better for 3 bucks at the hardware store. I have the silicone one for my other goggles 2. A much higher quality product.

I mean, yeah, its basically just a piece of weather stripping with adhesive on the back, but at least its been preformed to the shape of the goggles, I'm just not sure how you attach it? Are you supposed to remove the factory piece first? Or do you place this over top of that?

Removed the stock foam, attached the new foam with the adhesive velcro lined up and works great no more pressure on my nose. Gonna buy a spare to keep around.

Replaces original foam rubber works ok, & slightly better then original, you ,must remove the original, there are no instructions... but fitment could be better and a nose piece would help as light leaks there.