Goupchn LCR Meter Test Leads Terminal Kelvin Clips Cable Wires

Worked well on my HP/ Agilent/ Keysight 34401 multimeters. Flexible, fit and finish a very good value.

Nice lead flexibility. Reads accurately on my just calibrated DMM. Fits the connectors on HP/Agilent 34401A very well.

I bought these just to test the 4 wire resistance feature on a Keithley meter I was refurbishing, assuming I would buy/make a better set in the future. However, these exceeded all expectations and will meet my needs long term. Wires are good length and have supple silicone insulation - these are not stiff like some cheap probes. Banana jacks fit snugly. The alligator clip jaws align well. Repeatability of 4 wire measurements is within 4 milli Ohms - 20ppm for 200 Ohm full scale. I used a paint pen to mark the "force" side on the cable and the clip jaws to improve measurement repeatability.

Good value for the money and they work just fine.

I've seen a lot of test leads with Kelvin clips for more, but these seem to be the best. The pressure of each clip is consistent and firmly holds the device under test. The leads have a flexible and heavy duty insulation. If I had a concern, it would be the quality of soldering to the Kelvin clips. At first look, some of the soldered connections seem poorly accomplished, but the connection is solid. Be sure you insert the banana plugs firmly and completely into your meter. I was prepared to be disappointed when my 4-wire resistance measurements became flaky after a short while. I discovered that I had not fully inserted one plug into the meter. The plugs definitely fit firmly. I'm not saying that they are too tight, they simply have a firm fit which you want. These leads get a solid five stars for this review.

For accurate resistance measurements these would be hard to beat for the price. Low resistance leads, nice and flexible.

Very well made. Plenty of lead length. The leads are very flexible as you would expect in this application. Crocodile clips grabbing strength is very strong. Crocodile clips are a little bigger than I anticipated but ok. Had to cut away the plastic outer sleeve (gray portion) that covers the banana connectors to expose the contacts as the sleeve interfered with the connection to my vintage HP 3478 Multimeter. This did not compromise the connection or function after modification. Worked fine with my older (2-wire) Fluke 79 Multimeter before and after modification.

I got these to use with my Siglent SDM4065A bench DMM for measuring resistances under 100 ohms. I tested the leads on high-accuracy Dale low-resistance resistors, and the readings were spot on. The serrated jaws are perfectly parallel and grip very small wires securely without slipping.

低抵抗計メーカ純正の4線プローブが あまりにも高価なので、本品で代用。実測値は純正と変わりませんでした。心線も純正と同じぐらいの太さなで作りもしっかりしていました。

Very good quality for the price. May not be professional grade but works perfect for the occasional usage like we do. Works with our Siglent SDM3055 Digital Multimeter. Plug these in, short them together, REL on to cancel the ohms of these probes and you are ready to test low ohms. At these prices you can buy a few of these if you use them often and still come out ahead compared to more expensive units. I would purchase again. Very flexible cabling. Five stars for price to performance ratio. Pictures show meter and measurement of 0.1ohm rated resistor.

Works great with my Fluke 8840a. This is a must to have with a compatible DMM.

Very good quality and very soft to the touch.