– Sourcingmap 10 Pcs SS22F25-G7 2 Position DPDT 2P2T Panel Mount Mini Slide Switch Solder Lug

Used this for kids toy on/off switch which had started to fail. Can’t remember what voltage it’s rated to ….. I would generally only use this for lower voltages (max 50v say). But I think can operate at higher voltages. Works fine

Err sorry about the bad review, should have been on a different item, this is a fine switch as good as any equivalent part you might get from for example, Farnell.

Great works well

As described thanks

these were the type of thing I needed, but a bit small. I will use somewhere else.

They are fit for the purpose, they do what they are supposed to do.

These switches are actually much more rugged than you think. I bought them for a usage where I didn't want a big switch lever sticking out, because it was going to get smashed. Well, due to a mistake on my part, I dragged two of these switches through the dirt for more than a mile. Only one failed, which is a spectacular result considering the abuse it took.

I used six of these to replace similar existing switches on a guitar. All slider's are intended to be mounted on underside of a surface with the finger operated slider tab protruding through the surface top. So the protruding tab on these new switches is longer than my originals, gives me more "tab to grab". A great operational improvement!

Ho apprezzato tre cose di questi deviatori a slitta: i pin hanno l'occhiello per fissare meccanicamente i conduttori da saldare; inoltre è un doppio deviatore e non uno singolo, come se ne vedono in giro e che costano molto di più di questi; infine i fori di fissaggio sono filettati e permettono l'adozione di viti da 2 mm, senza dado. Ottimi per realizzare prototipi alimentati da batteria!

Ive used a bunch over the years for projects and they just work, easy to soldering to as well.

I have built Strat-style guitars with electronics modelled after the "Red Special" guitar built and used by Brian H. May ("BHM") of Queen. These guitars feature three single-coils in series with on/off and phase switches for each. I recently added pair of stand-alone pickguards using the same electronics. Each of the pickguards uses six uxcell mini DPDT switches and they have not disappointed. Of the several 10-piece orders, there hasn't been a clunker in the bunch. Soldering each of the teeny-tiny lugs is not exactly fun, but it helps knowing the switches will work as intended when I'm done. My only gripe is that uxcell does not include the m2x10mm mounting screws with the switches. (But it does sell them separately.) Minus 1 star.