Nilight 16AWG LED Light Bar Wiring Harness Kit 12V On/Off 3 Gang LED Pod Lights Rocker Switch Panel Power Relay Fuse 5Pin Toggle for Cars Boat ATV Trucks-6 Leads

Good wiring,fits great,long enough to reach in the spot I wanted it to be,easy to do,good conduction so good lighting.Functionability so far is great been having it for half a year or so for my 00 silverado that didn't came equipped with fog lights

I used the Nilight Light Bar Wiring Harness Kit to hook up spotlights on my CSC TT250 motorcycle. It worked really well, but I did have to trim the wires since it’s made more for a car or truck. Once I cut it down, everything connected fine and the relay worked as it should. The switch lights up red when it’s on, which is super helpful at night. The wiring felt thick and strong, and I liked that it came with a fuse already built in for safety. Just be ready to modify the length if you’re putting this on a smaller ride like a motorcycle. All in all, it’s a reliable kit that gets the job done with a little tweaking for bikes.+ Great price+ Solid wire quality+ Lit power switch+ Built-in fuse+ Looks sleekHope this was helpful!

Needed this for my led light bar I installed on my lawn mower. Wiring was eash to install and has a relay for protection of the led light bar. Really easy of installing it had all hook up for great functionality of this project. The brightest of this light bar has us able to mow grass into the night time hours.

I used this kit to install a pair of fog lights in the front grill of my '99 NB Miata. This kit was super easy to use. I used a fuse tap (not included, extra $5) to pull power from the ABS fuse in the engine bay, but you could draw 12v power from wherever you'd like. The rest was straight-forward. Two long wires run to the fog lights, install the blade connectors, bolt down the relay, and run the on/off switch through the firewall using the spare grommet near the throttle cable. The wiring diagram was very simple to follow.My only complaints were that the wire for the on/off switch could have been maybe a foot longer - it was barely long enough to make it around the engine bay and into the cabin. Also, a few extra blade connectors would have been nice. Finally, I would have preferred if the cable for the on/off switch used blade connects that you had to install yourself, because it's difficult to fit that big rectangular plug through the grommet in the firewall. It would have been much easier to run the bare wires through, then crimp on some blade connectors afterwards. That's easy to DIY though, but then you need extra connectors and you sacrifice a bit of length.Overall, great kit, would buy again.

I am using these for motorcyclea and cars - works great!You can modify the relay behavior depending on your case: remove the switch and control the relay through any circuit.Or keep the switch but make the relay to be controlled like above plus the switch!

Highly recommend for the car or boat I got it for the motorcycle and it was way too long did not read product information so I ordered a shorter version very durable very easy to hook up

Great price worked like it should!

Easy use