Original - Universal Scooter, Motorcycle & Bike OVER Grips for 7/8 inch (22mm) Handlebars - Enhanced Control & Comfort - Anti-Fatigue Foam Technology - Weather-Resistant, Non-Slip Texture

Easy to fit, follow the instructions and use plenty of slightly soapy water, and contrary to my fears of not being able to feel the heat of the heated grips - it didn't feel much different. If anything, felt slightly better with the larger diameter having more contact with my hands.The improvement in comfort with the fatter, softer grips is everything I hoped it would be.2022 Harley Pan America.

A little harder to put on than expected but excellent product. Great grip and very comfortable. I have an issue with my left hand (arthritis) and find my hand was cramping up in traffic using the clutch a lot, these grips have really helped.

Good product have bought several of them over the years.

Bought these for my motorcycle thay were easy to fit and very comfortable on hands.with no vibration,good value for money.

Work well but take some getting used to.

couldn’t be any easier to get on.put them in soapy hot water for 10 mins .get a dry tea towel slide them on job done👍🏻

These are great soft grips that give your hands a more 'meaty' feel. Love them and had same on previuos bike

As described - good quality

Awesome

Great, can’t say enough about the results, some soapy water and it goes on easily, feels great in your hand riding, dampens vibration as expected.

Pricey... But worth difference they make. Easy to fit, I use a tiny amount of Fairy Liquid and they slide on easily. Measure and cut with scissors before fitting. Highly Recommended

Le produit tient parfaitement les promesses de son argumentaire.Recouvre joliment mes poignées usées, facile à installer et ajoute un confort très appréciable à la conduite.

All good. The product also is way better than expected. Before buying I had a chat with an Noise and Vibration Harshness engineer asking him how to reduce the amplitude of the vibrations that would be transmitted to my hands throught the grips of my bike when I was cruising around 100kph. After realising that my engine would be at 4000 ish rpm at that speed and that the frequency of the vibration would be around 133Hz, when I showed him this product, and seeing the modest price and the material it looked like it was made, he encouraged me to try it before resorting to more expensive mass dampers.The outcome is that it reduced the vibration enough to not cause me wrist pain (that I suffered before in trips longher than 3 hours). The diameter increase is neglectibe and it is easy to adapt in few seconds. The installation is easier than some people say: I went close to the bike to see how much I had to cut, took the scissors (a cutter would have been better probably), decided to cut the part that would go close to the handlebar (the one pointing at the center of the bike) to mask imperfections in the cut (grip puppy are symmetrical so doesn't matter from which side you cut), for the accelerator, the grip puppy shall not touch the fixed part of the handlebar or the other extremity (it has to be free to rotate), 1mm clearance each side is enough, then water and handsoap, about 40ml combined, applied on the internal part of the grip puppies and a bit on the bike's grip(rubbed with the hands), then just push-twist, in 60sec per part it's installed. Let it dry for 1 day.I have not tested other brands, so my opinion might be a bit unfair, but its true that I was looking for something that could work, I went for this brand that looked the best while maintaining an affordable price, and I would do it again.