Bronco Factory Spec, , Carb Rebuild Kit 1996-2005 Yamaha Wolverine 350 4x4 YFM350FX

Gaskets and o-rings are smaller/thinner than oem. The needle jet was the wrong size/taper. The other pieces (main jet, etc.) worked but I would not purchase this kit again or recommend it to anyone. I wasted a lot of time trying to tune the carb (different combinations of needle jet clip positions and fuel/air screw settings), just to ultimately use the oem parts that I had planned on replacing with this kit. I used some of the pieces from the kit and some of the factory parts I already had (like the needle jet), and finally got the carb properly tuned. Best advice I can give is to stick with oem parts when rebuilding the carb.

Good product

parts were as original on my 98 yamaha wolverine. fit and worked fine.

Rebuilt carb on 98 Yamaha 350 wolverine runs like it's supposed to. The o ring's where a little small used my old ones would purchase again .It's great to have the old Yamaha back .