ALECPEA 30g Professional Silicone Glue - High-Flexibility Instant Adhesive for Silicone-to-Silicone Bonding - Waterproof Clear Glue for Silicone Rubber, TPE, TPU Repairs - Sets in 15 Seconds

How can there be any negative reviews about this product. I took 2 1/8 silicone hoses and cut it into 4 different section. I used the included reduction fitting and just put enough around the edges on just one tube- instead of holding for 5-10 seconds-( having previous experience with a rubber glue called KISS- which at the time years ago was the only superglue that was flexible for both rubber and silicone) I held each section with enough pressure to not cave the tube, for 30-40 seconds. Then I went to a 1/4 silicone tube and cut them into 4 sections. I waited a full 24 hours instead an hour or so to set and cure. I now had 4 tubes that were glued using this product. I pulled and stretched it to more than double its length- the silicone tubes were not only glued (fixed) together, the tubing retained its flexibility-with just a little bit of material on the edges-that were a little hard. Most importantly the flow of any type of material- within reason- there was no blockage and then I pulled with real force. The silicone started to tear at the seam but it held and I could observe the flexibility of the product. It tore a little but held and their was no leakage. This product is beyond my comprehension. I didn’t know it even existed. I took the 3 leading silicone superglues on the market and this one outperformed by a wide margin. I did not try to see if it was ready in an hour 2 - I waited 24 hours. Incidentally the tubes looked like they had been welded together. A perfect even symmetrical joint. This the very best product I have used to date. It’s difficult to believe advertising because so much is that if music was advertising- they sing a fine tune. I know this is the real deal and know if you follow my procedure their is no chance of failure. I might add that I did not- did not - use isopropyl alcohol to clean the joints to clean the joints. Just a microfiber towel to wipe the cut ends before joining. I might also add when cutting the silicone tubing into sections. I used an internal metal rod to make as clean of a straight cut as l could. They weren’t perfect. It didn’t matter. 2 days ago I wrote this review and tried another test. I had some old silicone ear tips that I occasionally wear. I made the best cut I could on the stem and it was not straight. It was jagged and out of round. It didn’t matter the product welded the stems together as long as their was enough pressure where the silicone from both ends were crushed( if crushed is the right word) I did not clean the stems in any way, did wash my hands. In closing, this silicone superglue is fantastic. The real deal. I am elated that technology and chemistry have evolved to make this product available and that it actually works better I think than advertised and as good as advertised. It does require some practice and a little finesse to go along with it. Try some discarded material first once it meets your expectations- just do it

Bought the silicone version. This stuff works great. Is bonds instantly within a few seconds, and bonds very tightly to silicone within the 24 hour time period. It's almost as if the bond is as tight as it was before the tear. Be very careful with this product however, if you apply too much it will drip and you have to remove the drips as fast as possible because it dries within a matter of seconds. All you need is a tiny amount when gluing silicone together. Also, wear gloves. When this stuff gets on your hands, it's nearly impossible to rub off.

I purchased this glue around six months ago to mend a strap made of silicon rubber. It was easy to dispense and bonded as advertised. The strap has remained flexible and is still holding together under consistent use. Disappointingly the glue has not kept well in storage, even though it has been stored per the manufacturer's instructions. The glue has gotten very thick and close to drying out despite being tightly sealed in its bottle, the zip-lock bag it came in and stored in a temperature consistent cabinet. More than 3/4 of the glue is now wasted and unusable. This is the same thing that happens with off the shelf super glues and similar. One gets one to two small uses of it early on and then later when needed again it's of no use because it dried out. Another six to ten dollars down the drain.

I bought this for my needoh nice cream cone because my brother ripped a piece of the cone off. When I used it, it started drying and crusting instantly so I couldn’t even glue it back in the right way. The glue was like super glue and it was liquid. It got everywhere. Now my $18 squishy is crusty and ruined and it even ripped because it stuck to my hand and I couldn’t get it off so I had to rip it off. There is also glue on my hand that hasn’t come off for 2 days. I’ve soaked my hand in warm soapy water for an hour, I’ve scrubbed it, scraped it, and it still hasn’t come off.

Works very well. I used this on my daughter's silicone doll and it worked great. I will be using again if needed.

So it is a cylinder shape of toy that made with very soft yet thick rubber like silicon, aqnd it was torm with a crack, i used the this silicon glue, and only placed the glue on 1 side and pushed the other side, and both sides adhered to each other instantly!!! However, here comes the problem, so yes, the crack is now sealed, i no longer need to worry about it would crack more. but.... after waiting for 24 hours to let it completely dried, the spot that the being glued together now hardened and this is an intimate toy that the silicon is supposed to be making direct contact to my skin, and perhaps with repetitive rubbing motion too, with its now hardened, how is it possible to still provide the same purpose to me as an intimate toy??

It works bonding silicone. My daughter's "NEE DOH" fidget squishy toy's cap came unbonded. She has sensory issues and when she finds something she likes, she holds onto it forever. So, it was a crisis when this thing broke. looked up silicone to silicone bonding glue and this came up. Crisis solved, it works great. Just ensure you have enough surface area to bond.

This worked way better than I expected. I used it for a small silicone repair on my watch band and it bonded quickly with a strong, flexible hold. It sets fast, so you do have to work a little quickly, but once it’s in place, it holds really well and dries clear. Such a handy thing to have around for quick fixes instead of replacing something completely.

Perfect silicone glue. Good for toys, spray nozzles, everything!

Used successfully on 100% silicon, and used as superglue on metal, plastic and paper. comes with 2 superfine nozzels. BUT do NOT glue your fingers together (Not that...)

It works great..better than the stuff the manufacturer gives you in a tube. Makes you a pro repairing with little effort. Just trim the edges where it bonds if you put too much by mistake.

Sticks silicon to silicon with no problems. It takes longer than the usual 10 seconds for super glue to set but after a couple of hours you won't be able to break the bond. Smells like typical cyanoacrylate glue but super glue doesn't stick silicone at all and just flakes off. This is amazing stuff.

Highest quality!