ANTS PART 5PCS Extended Roof Rack Cross Bars Kit for 2021-2026 Ford Bronco

High quality. Definitely more attractive price wise than OEM. As another review stated, instructions are not the best. Hardware isn't marked. Just sort and lay it all out. Go piece by piece and it's a breeze to install. Everything lined up perfectly. No missing parts. Extra front load bar can be ordered, although note that's different than the light bar. Noticed a little extra wind noise once I installed that. Otherwise no difference to inside noise or mpg's

Review update: Have to swallow my pride as the correct covers were included originally. They did not appear to match what I saw in the pictures and how it seemed they would connect to the two sections of side rails. I’m not happy with how the ends are exposed after the covers are attached. But at the end of the day, it’s a great value for the price. Fitment could be improved, but decent for the price. So far it seems functional. Will report back if any issues after mounting kayak rack and using it. Original review: Cannot recommend this at this time. Will update review pending resolution with vendor. Missing the covers for the middle section crossbars. The kit included two sets of the rear covers. The instructions weren’t the best but not terrible. The kit included several flat washers and lock washers. But doesn’t tell you to use them or when to use them. The tubes are aluminum and the connecting parts are plastic. If they can get me the missing parts I’d say this isn’t a bad kit for the money. It looks similar to the OEM rack with a rear extension.

DOES NOT ALLOW PANEL REMOVAL OF 2026 HARDTOP. Seller did not help resolve issue.

Rack is great deal vs. OEM rack!! Looks the same and does the job...

Ford should have built it this way. You can usually find the OEM cheap used but you're still missing out on the back half of the rack. Recommended!

The roof rack is solid. A great value for the price. It installed easy in spite of the instructions. Some of the parts were mis marked etc. I assembled it on the floor behind the bronco. It only goes together one way. Once the parts were lined up I put each rail together leaving the screws a little loose. I then mounted the rails tighting the screws then mounted the cross bars. The allen wrench provided is not much good. I used 1/4 inch drive T30 socket . The instructions did show what size screws were needed for each part. There are adjustment screws for tightening the rear mounts. I like that additional cross bars can be ordered.