Raven Concealment RCS Holster Wedge for Right Hand - Holster Accessories for Men & Women

Mounted this little guy on the back of my Stealthgear Scorpion. The hole spacing was off by 3/16" but I was able to squeeze it into submission. I probably should have used the longer screws that came with the wedge, but they would not have matched the contour of the washers. I also had to remove the two rubber spacers, but that's just temporary until I find the right balance between spacer thickness and screw length. Put a drop of locktite on them and tightened them up. Without the tension provided by the spacers I actually went too tight the first go-round and actually pulled the nut through the wedge holes, so be careful. No damage thankfully. So I guess I wrote all this to get to this point.....don't hesitate to buy this and try it out. I'm actually surprised how well it works with my Scorpion holster, and the function in awesome. Tucks the grip of my XD even closer than the claw, and also eliminates some of the pain I used to feel when crouching or sitting. Only thing I could suggest to RC is that they make some other versions with different hole patterns. 1 3/16" center to center isn't very common lol. Either way, I like this wedge so much I might even try out the Edilon one day. 😉

I buy these for all my holsters. It's a just have for me to get the butt of my firearm tucked in closer to my body. The only reason I didn't give 5 stars is because this didn't come with the mounting hardware. For some of my holsters It's not feasible to drill and screw the wedge on in which case I simply use some Gorilla Glue and clamp it in place over night. That being said I still would have liked the hardware. Great product.

I’ve been making holsters for a couple years. I’ve bought or built just about every style appendix holster out there. Experimented with foam or molded in wedges. Different depths, light, no light, flex, sidecar...you name it. I work at a shop and my boss is constantly telling me to show the customers how I make a full size pistol and light disappear under a t shirt.This wedge makes it possible....comfortably! Yes other parts go into it (DCC clips, holster design, wing, belt -but without it the holster would be removed as soon as possible instead of only when I go to bed.I only wish I could find another couple in RH (I can only find LH for some reason).

So who needs one of these without needing hardware? I had to drive around town for 45 minutes before finding something that would work (but not perfectly) at the Ace Hardware store. The product itself is of good quality and I wear it on my holster daily.

I didn’t have mounting points on my holster to attach this wedge, so I used Velcro. I made sure to heat it up with a hair drier and pressed it in thoroughly. The wedge is now securely attached to my Garrett Silent Thunder Slim II and it looks like it’s going to stay that way.

Works well but kinda of hard on the body

. ordered from Amazon warehouse. Resale “Like new Condition”. Looked new to meAnd and included mounting hardware & included mounting hardware. Made from durable hard rubber. Not very comfortable (hard lump, rubber clings to shirt ) however does prevent Kydex appendix holsters from flipping forward when installed properly.

Got this for a T-Rex SideCar IWB holster. I knew it wouldn't be an exact fit but I did not know that it was hollow with just a few reinforcement ribs on the back side. I planned on using a very strong 3M double sided foam tape to attach it with but there's not enough surface area on the back. I ended up having to fill it with silicon adhesive to attach it.Overall it is a small, hollow, injection molding of a thin, soft polymer. I can't imagine it cost more than pennies to make. I'd have done as well or better cutting off a section of a tennis ball and doing the same attachment...