RTSTEC Tilted Tumbler Turner for Rhinestone Diamond Tumbler Tool Bling Snow Globe Tumbler Making, Can Hold Different Size tumblers

LOVE THIS! It makes the whole process of blinging a cup way easier and at such a good price! Until this one, I had only seen 3D printed ones online and they were always around $80-100 - which was just not a price I wanted to pay when I already spent money buying the cups/paint/rhinestones.The piece itself is well made & spins perfectly. I've used it for both skinny, tall tumblers and the smaller wine tumblers and it worked perfectly for both. If you don't want to hold your cup or lay it down, this is the way to go! Highly recommend.

I loved this, but then upon using it twice the screw stripped and my husband had to re-do the dowel. I may have gotten a bad one, but the design is great!

The media could not be loaded.  This turner definitely helps when rhinestoning a tumbler. It has spared my hand/wrist from holding my heavier tumblers (I have carpal tunnel). There are def a few things to note:1. Way way cheaper than the same 3d printed system, from a popular seller, on Etsy.2. The wood "spoke" hardware was screwed in at an angle and didn't bite the wood very well. We unscrewed it, slapped in some Liquid Fusion glue, and re-piloted the hole. We then glued the spoke to the pink base (glued the screw on pink base to the hole on wood spoke).3. Screws and nuts seem to have also been glued in place and/or screws canted when piloted in. This doesn't allow for too much room in adjustments. One of the plates used for the ball bearings is kind of canted which causes the smoothness of the spin to be a little bit wobbly. We tightened everything as best as we could and while it helped smooth out the spin, it's still an uneven spin (though only slightly now).4. Ball bearings are greased very well. Spin should be smooth when things are aligned/tightened right.5. Solid wood construction. I've been using a 32oz PLUMP tumbler and the holder has stayed sturdy to where I've placed it.6. The foam inserts are handy for a variety of cup sizes.I recommend using this purely for rhinestoning. Because of the wobble, if doing any resin work, it will cure unlevel (this is also not a motorized spinner). Even with all of the above, I do recommend this for your blinging needs. Especially at such a low price point compared to the 3d printed brand.