4Pcs Car Door Lights Logo Projector Compatible with LS/ES/is/LX/RX/GS/GX/RC/UX Car Accessories, No Fade HD LED Car Welcome Projector Lights, 3D Ghost Shadow Light

These lights are awesome. If have a 2025 Lexus TX and using the included adapter they fit perfectly. Nice logo displayed on the ground and lights for the side. Installing was quick and easy.

Very easy to fix! Even came with a small flat head screwdriver. It took all of 5 minutes.Had the adapter cables required.Quite bright and visible in dark spaces. Looks nice

Took 10 seconds to install. Very simple, quick, and GREAT quality. Sharp and crisp image, and elevates the Lexus experience!!

The media could not be loaded. Looked great, and were exact replacement for the OEM, but for some reason, drained my battery. So had to remove them and send them back. Wish that was not the case, because the logo projection was absolutely gorgeous.

These installed easily and fit perfectly into the OEM slot. The light is very bright and the clarity of the Lexus logo is extremely cleab and OEM looking.

Easy installation! Adds an additional flare to your vehicle.

I was initially excited about these Lexus logo door lights for my 2025 Lexus RX350h, but that quickly turned into frustration and serious concern. The first two worked fine, but the third one started smoking the moment I connected it. I had to yank it out with my bare hands to prevent what could have easily become a fire. This is a serious safety hazard—completely unacceptable. I immediately reinstalled the original light because there’s no way I’m trusting this product not to damage my brand-new car or put me at risk. I’ve requested a refund and strongly advise others to think twice before installing these. Amazon and the seller need to take accountability for selling products that are this dangerous.

I purchased 4 Thingrific Door Logo Lights for my 2021 LEXUS ES250. I needed to use the supplied wire pigtails to mate with the door connector. It was sporty since there were no instructions or pictures. I was unsure if the new logo light has reverse voltage protection, so I used a magnifying glass to view the printed circuit board to determine which post was hot. I think the top post in connector (with projector facing down) was hot and hooked red wire to those. I forget to take a picture. I matched black wires when connecting with car wiring. I put electrical tape around both set of connectors for water tight connections. You must give it a sizable thump to get the lights to seat properly in door panel. They all work and display well on the garage floor. I will check again in the dark. It took around 30 minutes to complete the work. I sure hope that they are reliable and have longevity, but so far, they are 5-star.