WEN CT9502 100-Inch Track Saw Track Guide Rail and Adapters

Best quality and well product. I suggest everyone go for it blindly.

Excelente guia para mi sierra, corre suave tiene buen agarre y lo principal esta derecha y se pueden hacer cortes longitudinales sin problema

I recently purchased a Milwaukee track saw and bought this as a placeholder until I could get my hands on a Powertec or Milwaukee track guide rail. The funny thing is that the WEN guide rail does just as good a job for a fraction of the price. I also bought a 110" Powertec guide rail to test out the difference and I am here to say that the WEN guide rail is just as good for over half the price. I even used the back of the WEN guide rail as a straight edge when using my router to cut dados/rabbets. If I was forced to pitpick... the only thing I might say could be improved is the way the 2 rails connect. Using an Allan key is fine but they are easy to lose (which is why we all have 50 different types/sizes). Is there a way the rails could clip in and then tighten with a knob? Thank you so much WEN for providing good quality at an affordable price. I will most definitely check out more WEN tools/accessories moving forward.

Excellent choice! I read about many other track saws and this one came up. After reviewing I settled on the 6.5" diameter blade since it was more commonly available than the 6" (Grizzly) which made it lower cost. The quality of the saw and the track is very good. Many metal parts so it is weighty, which actually makes it feel secure to the track. Adjustment knobs are plastic. One comment I read indicated the sawdust discharge was in the wrong position. Mine came with an adaptor that allowed me to angle the discharge away from me. I ran it with a vacuum attached which solved the discharge problem all together. All cuts were very precise. The built-in stop for an initial shallow cut on a thin veneer was convenient. Downside was you have to make (2) cuts, but the results were stellar. Definitely buy the Wem F-clamps (36053C 6" Quick Release), you will need them and they work with the track slots (and other T-slots you may have). Although the kit comes with a rough cut blade, I ordered a Wen 56-Tooth Carbide-Tipped Thin-Kerf Professional ATAFR Track Saw Blade with PTFE Coating for a smother cut. I highly recommended for furniture grade ply's. I cut (3) sheets of 4x8 oak 7-ply into 10" wide shelves. Still sharp at the end. This was a good investment.

I bought these tracks to go with my Evolution track saw. They work better than the actual Evolution tracks that came with the saw which are 3 short pieces totaling 40”. This pair of Wen tracks are ideal for ripping 8’ material. They are sturdy and accurate. Now I don’t have to keep up as much with which edge is factory on sheet materials. With the right blade, every cut is just as good as the factory edges. I have used these to rip straight edges on rough sawn lumber as well. Well worth the price!

Glides almost as smooth as my Makita track but costs half as much. Definitely worth it!