Replacement Vacuum Fan Impeller Kit for Kirby G3 G4 G5 G6 G7 G7D Sentria I & II Part # 119096S

Passt und tut was es soll.👍

I had the impeller on mey kerby vacuum replaced, the belt pulley didn’t match the original one and after 2 months of the new impeller it shattered into pieces, don’t buy part from this seller unless you want your $3000 vacuum ruined

very good

Worked for my G-10D Kirby. After 12 years and shag carpet, its like brand new again with the new part. Its been a few weeks since the replacement and have had no issues. Be aware, the inpeller fits very, very, very, snuggly. It took longer to get the impeller fan on than it took to disassemble/reassemble the vacuum. A propane torch to heat the old one for removal. Wd40 to help get the new one on. And RTV silicone for the new gasket.

I was repairing the fan assembly on my Kirby G4D. The part is listed as fitting the Kirby older Generation models. IT DOES NOT! The hole is too narrow to fit the shaft of the Generation models. I took it to a Kirby repair shop. The owner said it is not an OEM product endorsed by Kirby. It was yellowish in color and the logo was wrong. He stated they would be white even a little greyish but not yellow. He sold me the correct part for $22. He did not reccomend drilling the hole larger since this would compromise the parts strength and it would break within a couple weeks. Also the machine would possibly be loud and it could damage the machine. My older fan part was firmly on and it took WD40 and the help of a second set of hands to wiggle and pull it loose. Do not try prying under the blade. As another reviewer stated, It will damage the shaft. I replaced the fan blade on another Kirby and I had to remove the handle assembly (which is held on by 2 screws on top) to reach the motor shaft with a 9mm wrench to keep it from turning while I unscrewed the old end piece. Hope this helps it was a very easy repair. Remember to purchase a tube of selant.