Generator Transfer Switch for Gas Furnace, Oil Heater & Pumps, by Journeyman Pro | Easy DIY Install Kit, (1 or 2 Circuit) Manual 125V-15A, 1875 Watt | Not UL Listed

it was very easy to install , my only complaint was the flex cable shielding was actually the wrong size to fit the connectors on each end 5/8 instead of 1/2 inch

Would not use again, very light duty controls and dose not come with a wiring diagram.

This is a well built simple transfer switch. All of the components are high quality and UL listed. the actual device is NOT UL listed. The build quality is really good however I found that one of the neutral wires WAS NOT crimped and fell right out. Fortunately I opened the case to inspect the wiring before installing it and was able to correct this. I installed two of these units to cover four circuits. They include all the hardware you need which is nice. Even the wire nuts and conduit. The written instructions were a bit confusing telling you to tie the "red wire to the black" in step one which didn't match the schematic. I ignored the instructions and used the schematic and everything worked fine. Overall it's a nice product I just caution you to inspect it before flipping the power back on.

Product was packaged Professionally, Shipped Promptly, Instructions are well written with diagrams...Easy to Install, will recommend to others. Install time well drinking coffee and admiring it about an 1 Hr. I Purchased the Two Circuit Unit..

1. No wiring instructions in the box. I had to refer to the diagram used in the description.2. The Flexible conduit provided is 3/4" and the fittings provided were for 1/2" (why I gave it 4 stars).I have not finished the install but I'm hoping it operates as promised.