🔧 Connect with Confidence!
The IDC20 2x10 Pins Male Header Breakout Board Terminal Block Connector is engineered for seamless integration with a simple DIN rail mounting system. Featuring a robust FR-4 fiberglass PCB with dual copper layers, this connector supports a maximum temperature of 50°C and accommodates up to 60 volts and 1 amp of current. Its compact dimensions and versatile 10-position male header make it an essential component for any professional setup.
| Upper Temperature Rating | 50 Degrees Celsius |
| Number of Positions | 10 |
| Number Of Contacts | 10 |
| Mounting Type | din_rail |
| Voltage | 60 Volts |
| Current Rating | 1 Amps |
| Connector Type | Screw |
| Item Dimensions W x H | 2.76"W x 2.01"H |
| Centerline Length | 51 Millimeters |
| Gauge | 16.0 |
| Pitch | 2.54 Millimeters |
| Material Type | steel, Brass, Copper |
S**D
Just what I needed
I used this to wire up the output of my PLC DC Output card to a bank of 16 relays. Now I’m able to use these relays for higher voltage/current applications. This will allow my controller to be isolated from all the equipment it controls as well.
G**S
Easy to use
This breakout device made my project prototyping much easier. The screw connectors make attaching and removing wires a snap. It would be almost impossible to work with the 20 wide flat cable without this breakout board.
R**Z
Compact and cheap
This break-out board works as advertised. However, the wire binding posts are small and only accept smaller gauge wire. The compact design prevents installing or removing ferruled wire installed on the lower block. Silkscreen of pin designators are clearly printed. Overall, the quality is good.
A**H
Great breakout board, works as intended
Connected this board to a capacitive touch led screen via a ribbon cable in prototyping stages. Would have been miserable wiring everything without this breakout board
A**X
Works but has issues..
Thi as item works and could be a good breakout boards... i purchased 8 pieces and 3 pieces has issues with pin out no 5.. there is no continuity between out soldered side and pin out connection..... these board may not be properly tested for QC issues...
B**.
Nice product
Providing the mounting brackets was very useful.
Trustpilot
1 day ago
2 months ago