Big Red 1/4 Inch magnetic quick change bit holder,hex shank drill bits holder for impact driver,screwdriver bit holder extension,BHT-STIBH01

The media could not be loaded. I love this bit holder. It works well on both 1/4" long shank bits and 1/4" short shank bits. Insert the bit and then just push it in. The collar snaps down and locks the bit in place. The magnetized holder will help hold screws in the bit. To remove the bit, pull the collar out and it clicks into place. Grab the bit and easily pull it out. Many other bit holders you have to use pliers or have strong fingers to pull out the bit, especially short shank bits. Or, other holders don't hold the bit in tight enough and the bit falls out after you drive the screw and you will be looking on the ground hunting for the bit. Get this bit holder. It works great. 💪 👍 Look for my video review demonstrating its use.

I installed it, and it looked good and held the bit just fine. The bit broke and I could not move the sleeve on big red to remove the bit so I had to throw it away. Even used pliers to try to twist and pull the bit out, while holding the collar up to remove it. I use drills every day, so I understand how they work and this one did not!

It's too bulky in the head area where the bit goes. Hard to get in tight spaces haha. Anyway I would recommend it but for maybe a first-time user or somebody doesn't use a drill too often like around the house or something other than that I don't recommend it.

Worked great at first, loved it. It no longer will hold the bits in place.

Broke in two the second time I used it. Definitely bulky but far from strong

This thing broke after a couple months of regular use.