Billet Aluminum Connecting Rod (3.308") For Predator 212cc Engine Go Kart

Installed them and been running the hard no issues

Bought this not expecting much and guess what that’s exactly what I got, inferior bolts is an understatement, per instructions bolt snapped right off at 57.2 ft lbs. I have a highly accurate snap on electric torque wrench do not buy this rod.I left 5 stars so this message gets to the front page.

Great fit, better alternative over a stock connecting rod.

Does not even come close to fitting Stock crankshaft as advertisement states had about an 8th inch play after installed

It came in a paper bag with a small box inside with no protectionLooks almost like the ARC rod but the rod bearing are visible cheaperI just installed it in my engine with no problems let’s hope it last

Good rod

This is the second one I've bought. On my more serious builds I use ARC, but for my mild builds these are fine. Install is just like the ARC, BUT, keep in mind these use inferior rod bolts. That being said, I followed instructions with the rods wet with oil, and torqued fine up to 150 inch pounds. Use a GOOD and reliability accurate torque wrench and you won't be one of the guys complaining in the reviews about the rod bolts snapping. Yes, the oil hole in the included rod bearings won't perfectly line up with the oil ports on the rod, but there's more than enough room for oil to pass. If you don't like the inferior rod bolts and the slightly off oil holes on the bearings bother you, simply pass on this and get the ARC rod.

It don’t work and mine came in silver

Ich es sehr gut außer dass mir ein Bolzen gebrochen ist aber ich konnte ihn mit einem M6 Bolzen ersetzen und sie haltet auch sehr gut durch bisher über 7,500 rpm und ich empfehle die Pleuellager von ARC zu bestellen weil die was bei mir ankamen waren falsch Fabriziert deswegen, habe ich Pleuelklopfen bekommen.

The rod comes shipped with the bolts tight af. The threads of the rod on one side stripped out just loosening the bolt. I wont even waste time with putting this garbage in my engine. Just go for an ARC this rod is not worth the time and money.

Had to get piston side honed 30thou, bushings didn't clip in nice, probably 3 or 4thou slop on the crank. Bolts should be a e10 but just don't fit right so can't torque to spec. Spend the extra 40 bucks and grab an ARC.