Rear Bumper Protector Compatible with Volkswagen Atlas 2018-2025

Installed on 2023 Mazda cx5. Removed half side tape covering and installed from center out. Then removed other half tape covering and again installed from center out. Pressed firmly. It looks like it was there from factory.

Wanted more protector the back bumper and this was it. Easy to install and holds up to many automatic car washes so far

It looked great on the Audi, too bad I didn’t keep it long enough to enjoy it. The adhesive was great and it didn’t fade during numerous car washes

Fit was pretty good - I cleaned the area well, then wiped with isopropyl alcohol before sticking the guard on the bumper. Goes without saying, but line it all up and test fit before sticking it down, because once stuck you don’t want to pull it up!To early to tell if it’ll last on adhesion, but it does look good on my dark blue Audi with black-out logos and no chrome. And it’ll save me the scratches everyone else puts in my bumper with luggage and putting stuff back there.

This bumper protector is easy to install and I had it for a fee years and it still looks great.

This product was about half the price of what the dealership wanted, and I think it looks better than the cheap looking chrome one VW offers. I understand that this was a generic product used on various vehicles, but in the end, it looks FACTORY. Some reviews mentioned there was a gap on the lip and it didn't fit right...but I didn't have that problem because I watched a YouTube video by "MAC'S DIY" called "2018 VW Atlas - How to install rear bumper protector" and it helped me achieve a perfect installation. Yeah, you can slap it on and be done with it in 2 minutes or you can take your time and spend the 10-15 minutes to make it look right. My vehicle is a 2019 VW Atlas, but they're all the same, unless you have a CrossSport which is the smaller vehicle. A few tips: Clean your bumper with rubbing alcohol and dry it before applying this protector. Razor blade the paper of the pre-installed 3M tape underneath so that you can press down a section at a time. Start at the middle and press down and forward making sure that lip is not leaving a gap. Watch that YouTube video, it explains everything you need to do!

Perfect fit and not outlandish. Just what I needed on my Turbo!

I have had the Dawn Enterprises RBP-005 Rear Bumper Protector on my Ford Explorer for 2 years. With dog kennels being loaded daily, the bumper protector has held up and stayed in place. Does it's job of protecting the painted bumper very well. Highly recommended and it is worth the price.

Fits but to be noted this is not a vehicle specific cover, it’s a generic part. You are expected to bend the cover as it is installed to conform to the rear bumper of your vehicle. Out of the box it does not fit, bending during install provide a close enough fit. So the fit isn’t perfect but it will protect the bumper. Happy with the purchase so far. Tracking provided was for fedex but arrived with canpar. So tracking provided was no good but it arrived.