Car Seat Latch Anchor Kit - Converts Older Cars to ISOFIX Compatibility Interface, Child Safety Car Seat Adapter Tether Bracket Mount for Vehicles Heavy-Duty Steel Easy Install (Check Size Before Buy)

Our 2015 Toyota Sienna has limited third row options when it comes to car seat locations. Third row only has connectors for passenger side and center, but not driver side. We wanted to be able to have an obstructed view of the rear window and also wanted to keep our two older boys separated with a little space, not right next to each other. Only option for driver side third row is using the seat belt, but there just isn't a good way to get the car seat fastened firm enough without leaving a bit of shifting movement.This fit fairly well, with the only obstacle being something that is not the adapter bracket's faults. Behind the Sienna's third row is a flap that hangs down, over, and just slightly past the exposed crevice where the bracket would feed through. This wouldn't be an issue if the flap didn't extend half an inch or so beyond the crevice, but as it is the bracket only sits flushly when the flap is completely flipped up and bracket pressed against the resulting bulge. The flap is made out of a relatively thick upholstery and backing material and when flipped up does not allow the bracket to sit nice and flush against the seat. It is good enough though without altering the flap. A solution to this on the manufacturer side would be to include a small dip along the length of the corner of the right angle to better accommodate a flap without obstructing the positioning of the bracket. It would add a bit to the manufacturing process and therefore the cost, but that option is the one that we would have considered for our particular need if it was available. I do not see any others offered with such a dip, so the other styles are virtually identical.Installation was a tad difficult when done alone, but not impossible. Depending on the amount of cushion and clearance you may find it difficult to hold the bracket in place from one side while reaching over to fasten the guides. Two people would make short work of this if available. The guides are not necessary but once they are in place they hold the bracket nicely in place from sliding out when removing the car seat.

Easy install in my jeep cherokee XJ . Very secure. Highly recommend.

Quite useful in my 1994 integra coupe since it doesn't have car seat mounting points. Holds the seats in very firmly.

Wouldn’t fit my two cars I needed it for. Had to return.

Very helpful for older vehicles. We bought a couple more for our other vehicles

Good quality metal, but did not work as I had hoped it would

Works great securing my son’s car seat. In my truck with a bench seat and non ratchet locking seatbelts.

I bought this to put in my 98 jeep Cherokee it was super easy to install and easy to remove it fit perfectly and it functions as it should it sometimes slips down but i just slip it back and retighten the car seat base