JIUSHARK JF13K Diamond,Top-Down CPU Air Cooler,6mm x 7 Copper Heat Pipes 2×120 * 120 * 15mm PWM&ARGB Fans 250W TDP SuitableFor Intel LGA 1700/1200/115X AMD AM5/AM4

Great little cooler. A bit of a hassle to install, but looks great once in place. I ended up swapping out the fans so that the thickness of the cooler lined up with the vertically mounted GPU. The included fans were otherwise great and I've used them elsewhere. I feel this cooler would perform even better if my case had mesh panel, but then the look would not be as great haha.

Impressive performance. Cooled a 5800X3D with ease. Idle @ 30 degrees c. Never wanted the stock slim fans it came with. I knew that before I bought it. Fits well into a Silvertone GD05 HTPC case with plenty of room to spare overhead.

What I don't think most people know about this cooler is that it can also be mounted vertically if you have the right motherboard to do it. It also has standard 120mm fans which can be changed out for any other 120mm fan you want to make it perform even better and have different color combinations.

This is one of the most unique coolers. It is low profile enough and won't interfere with memory height. Only issue is it doesn't support ITX. If it supported ITX it would gain even more attention. The fans that are included are very basic but they still provide good cooling. I think it will be a top performer if you swap out the fans for 30mm thickness ones.

To put simply. My computer is now dead. Yes I followed the instructions, yes I removed the film from the contact plate. Yes, I'm now depressed because my 1200 dollar pc is dead and now I have NOTHING to look forward to after my 10 hour shifts at work. And no, I can't afford to just replace my pc.

The black looks really nice with ARGB halo fans you will need longer ME screws to mount standard 120mm fans. The mounting system on this absolutely sucks. The combo backplate is cheap, it works but would be nicer to have dedicated AMD and INTEL plates. The screws fit loose into the MB holes and have a small collar that pinches and could damage. the board. The screws are also too long if you have 6mm standoffs you will have to drill some holes in your case because the screws hit and will warp the board. The nuts should be replaced with low profile shoulder screws that fit the mb holes and some plastic spacers to set clamp pressure similar to how Noctura does it eliminating the board pinching. CPU interface had some sharp burs on the edges that I could feel with my fingernail. I used an 800 grit emery sponge around the edge to remove the burs. Temps are great on an i9-12900K. I would definitely buy more if they fixed the issues.

I used this with an MSI MPG Z690 FORCE WIFI Motherboard. While my case is huge I can see how this cooler would be a great choice for a small form factor/ITX build.

Overall, if you are building your first PC I would recommend you JF 13 K diamond CPU cooler it helps decrease CPU temperatures. highest I see was around 50 Celsius but the lowest I seen was 34 Celsius highly recommend if you are first starting your PC journey.