CNC Spoilboard Surfacing Router Bit 1/4 Inch Shank, Extra Large 1-1/2 Inch Cutting Diameter, Slab Flattening Router Bit Planing Bit Wood Planing Bit Dado Planer Bit(Carbide-4 Wings)

This is a must have for a small CNC router or router sled. Works as expected.

Fast shipping. Tool worked well. I would use this company again.

It works verry well for a cheap bit, my only real complaint is dulls out quickly and leaves burn marks verry easily little to easy. But in camparison to the high end bits and their price its verry cost effective and works for couple projects

Just received this bit, used it on a few pieces of walnut and maple. it left a very nice surface finish! The tolerances are spot on and its a great bargain for the price. The extra width allows it to remove more material quicker for the larger areas and pockets. Its nice that it has a 1/4 shaft so I don't need to switch collets between router bits. Works well, easy to use!

Perfect for my task and I can truly attest to the durability now. I had to reduce the thickness of some pine planks to fit for a project. Instead of spending a lot on an electric pass-through planer, I tried this surfacing router bit. I set the depth on my router to 3/16" and went over my boards twice to reduce their thickness by 3/8" inches. These were 8x 5 foot planks and each one needed about 10 passes to complete. My router is cordless and I had a battery cycle running laps through 4 batteries but I got through the task and this sturdy little bit held up and was still making clean cuts. I literally put about 40 sq ft of wear and tear on this bit over the 3 days it took to finish.

Made paining much quicker with my cnc for wood. Pretty clean just minor sanding if want perfect. They put bubble wrap in container to protect bit when stored away

I bought this flattening bit to go with the router I use in my router sled. It's a 2-inch diameter so it cuts a good amount with every pass. So far, it has held up well, with no issues with the sharpness. It's less expensive than some, so that's a good quality, since it is holding up so well. I recommend it.

They are so many spoil-board cutters out here where majority claim to have the best with their features. Give real CNC operators it's only a cutter, you're not making license plates. Buy cheapest to do the job, if breaks not much loss, but break a $70. bit that's going sting.

Looks like it will do the trick

Really high quality bit it didn’t fit to my router

Deja un buen acabado, sin marcas. Aunque es el modelo de tres cuchillas, funciona bien.

Work very well would purchase again

Heavy duty bit... cleans up the wood surface nicely, ready for a final sanding. Use this bit with a minimum 3/4 hp router. Stays sharp through some real tough hardwood.