3 Pcs MCP2515 TJA1050 CAN Bus Module SPI Interface Compatible with for Arduino Raspberry Pi ESP32 STM (CAN Bus Controller + Receiver)

Perfect for what I'm using them for.

They work great, and are pretty simple. Nice that they come with a termination resistor.

Fantastic item! I built a perfectly functioning CAN network.

Very easy to connect to Arduino and it works with MCP2515 libraries available in the Arduino IDE. 4 Stars instead of 5 because some boards have 8MHz crystal and some have 16MHz, I didn’t notice that at first, and thought the boards or code had a problem.

It does whatever it claims to do :) I am using with ESP32 dev module to read my car CANBUS and working perfectly. It also has SPI chip on it and gives you more flexibility to work with different SBC or development cards. ESP32 comes with built in SPI but I am also running really heavy software on it so that's why this one my first choice. Good things to know about this module: - SPI chip (works with almost any dev board) - built in 120Ω terminal resistor to reduce noise (you don't have to add one) - jumper pins for customization - small size - really cheap

Works great, but be sure to set the right oscillator frequency in the library you use.

It would never register in the OS, meaning the overlay would not load. It saw the MCP2515 bit couldn’t sync with it. I switched to a CAN hat, which worked correctly right off the bat.

They worked fine but I'm not impressed with the quality. They obviously must have done some quality control because I noticed one of the traces soldered over. Must have been a bad print. Still, I'd prefer if I guy a good one instead of a patched one.