Wztepeng 8" 55 Pin Touch Screen Glass Digitizer Compatible with 2015-2018 Chevrolet Suburban Tahoe Chevy Colorado Silverado GMC Canyon Sierra MYLINK Navigation Raido Replaces DJ080PA-01A DJ080PA-01G

After a lot of researching, I finally found this fantastic interface for my truck, was very easy to install, it works perfect now and fits very well on my 2017 chevy silverado and a chipper way to fix the glitch problem.

Says it only works for up to 2018, but it works great with my Silverado 2500 2019. I didn't think that they changed the head unit until 2020 so I took a gamble. Glad that I did. Touch response is great, easy to install and does better not leaving finger prints than the old one. If you have ghost presses where the screen seems to be changing all the time randomly, you probably need this.

The screen on my father's 2019 Chevy Silverado 2500 started having ghost responses and was dead in certain spots. The shop wanted to replace all the modules for thousands. After a bit of research, I realized it was just the digitizer. This is an excellent direct replacement. Be careful not to crack your dash fairings, and not to bend the metal tray when removing the old digitizer. Videos are avail on YouTube. This a few months ago and still working great! For $50ish, well worth it.

Product was high quality and installation went off without a hitch. I was skeptical that this would fix the issue for such little cost but it did the trick. Less than an hour of my time too! Would definitely recommend.

take your time. Hardest part was removing old adhesive. Works great.

Fixed my screen that was having phantom touch to not responding to any touch. There is a few videos on how to replace this part on YouTube but a few tips I did not see. You will need at t-15 torx screwdriver, 7mm socket, auto trim removal kit, acetone/nail polish remover, leather or thick rubber gloves, and a utility knife with a new blade. 1. This comes with new adhesive on the glass that you just peel and stick the the frame. 2. I did not have any easy time separating the old glass from the frame. I tried a hair dryer at first but I would skip that and just put it in the oven for a 3 to 5 minutes at 275 (make sure to wear thick gloves when working with now until it cools). This will loosen up the adhesive that holds the glass to the frame then use a utility knife to slowly cut in between the frame and the glass to separate. Use acetone to clean frame afterwards.

I was skeptical at purchasing this item, unsure if it would work or not. I went ahead and took the chance the part arrived on time, but with no type of instructions. Installation was fairly easy after watching a few YouTube videos. The part itself is slightly smaller than the original part, but still fits the area that it needs to the adhesive was not as robust as the original that was installed, but as of right now the clarity on the screen is much better And I no longer have any ghost, touches, inconvenient gps route changes, random pauses in the middle of my songs. Hopefully it holds up.

This item was an exact fit for my 2018 Silverado. It all ready had the glue on the screen so I didn't need too buy, which I did, the glue to fasten the screen. It fixed the haywire that was going on.