KUAFU Strut Tower Brace Compatible with 2008-2023 Dodge Challenger Front Twin Tube Design Red Steel Powder Coated

Once Amazon finally delivered the correct item, it looked good but it wasn't Tored like my Challenger is, so I put a couple of coats of red caliper spray paint on it and installed it and it looks great! Was a perfect fit too! I also got end caps for it. 😎👍

GREAT PRODUCT AND MADE WELL

The title says it fits a challenger and I took the risk to see if it will fit a charger. Mine is a 2020 dodger charger scat pack. It took some convincing and it touches your a/c line but it can be litely be bent away a little. Then you’ll have to start nuts on one side and the use a pry bar to get the other side to sit down. After that it’s just torquing all 6 nuts down! So long story short it will fit a charger!!!!! I give it 5 stars because it is a sturdy built brace and it says it is for challengers and I made it fit a charger

Doesn't fit. I've tried 2 and returned the first one. There is always 1 hole that is 1/4-1/2" off. 1 volt is on the edge of the hole but could probably be forced on if not for the one so far off. No amount of prying or adjusting can make it fit. The first one I received was the same way. Both were just tossed in a box and had punched through the ends of the box leading to scratched ends and damaged paint. Save your time and buy a decent one.

I installed this on 2015 dodge charger Hemi V8 and yes you can do it however please keep in mind you will need to do some work to make it fit. I had to drill out 2 holes for Clarence just so that it can hit flush. I have not taken it out for a test drive yet but engine bar looks good.. This will add some weight to your car because it is heavy. You can watch the video I uploaded to see what I did

Very good construction, once I repainted it to match my compartment.. it is great.. looks factory , Ver simple install, ( took literally about 5 minutes to install !!! ) into my 2019 Challenger Scat Pack.

Highly recommend! Had an issue that was fixed almost immediately, great seller, great product! We need more sellers to be like this! Very impressed!

At first it seems to not fit …… the fulcrum points don’t line up when just placed on top. Relax , take all the nuts off , fit one side place one nut loosely, then work the other side down, I pried mine back and down without a dead blow. Love the piece , looks great , can’t wait to throw the car in a corner and see the difference.

Fit parfait. juste changer la couleur un un meilleur agencement. Superbe qualité, identique au modèle vendu près de 500$ CAN.

Had to raise one side of the car, slightly, for the strut bracket to line up with the holes on the one side of the brace. Overall it fits fine.