20V PD USB-C Power Supply for ResMed AirSense 11 Air 11 Airmini 65W 20W ResMed CPAP Charger DC Coverter Cable

Honestly it's a cable that works so it's hard to say more other than the fact that the cable itself feels like quality cable without the unnecessary weight. Ultimately I picked this item up primarily for one bag travel with the potential to run off a power bank (more on that later).When I looked at the reviews I saw multiple individuals commenting on the cable not working so I wanted to provide what I use to insure that the FLGAN 20V PD USB C cable to work with a ResMed AirMini (in my case). I paired this cable with a Satechi 165W USB C 4-Port GaN Charging Station, based on the 3 & 4 port outputs (located on Amazon) port 1 will deliver 60W (however up to 100W, you need to check the Amazon diagram), 2 - 45W (however up to 100W), 3 - 30W, and port 4 - 30W. In essence you should be able to power a ResMed AirMini on any of the 4 USB-C Ports (I've been using Port 2 in most cases), if you are using a AirSense 11 you would need to use Ports 1 or 2 and would only be able to charge other devices on ports 3 & 4 or else the charger port drops below 65W. Overall a good pairing with the FLGAN cable.On another note, I attempted to use a Anker 737 Power Bank (AKA A1289, 24,000mAh 3-Port with 140W Output) and got the dreaded low voltage error message, the Anker site says USB-C1 and USB-C2 should support Output: 5V ⎓ 3A / 9V ⎓ 3A / 15V ⎓ 3A / 20V ⎓ 5A / 28V ⎓ 5A (140W). If you are looking to run your AirMini (or AirSense 11) off a Power Bank don't use the Anker 737 (A1289) it will not work. Hopefully the product pairing recommendations will help people out.Satachi 165W USB Charging Station:https://www.amazon.com/Satechi-165W-USB-C-4-Port-Charger/dp/B09PMDZWZ6/----- Update 01/09/2025 -----Unsatisfied with my Anker power banks inability to power the AirMini I went and purchased the Iniu 100W 25,000mAh Mini and tested it and voila! We have lift off (see picture). Below is the link to the Iniu power bank that I purchased, unfortunately Amazon only carries one color but this should help anyone in need of a ultra compact power bank to pair with their AirMini:https://www.amazon.com/INIU-Charging-25000mAh-Ultimate-Compatible/dp/B0DBHC9F8B/

I plugged the FLGAN USB-C power supply into a new ECOFLOW Delta 3 Plus with more than enough power to run my ResMed AirSense 11 and it simply wouldn't work. It just kept blinking. Didn't matter what end I plugged in first. I had high hopes that using DC would allow me to run my CPAP longer while camping. Amazon's AI assistant said it would work with my power supply but it doesn't. Returning it today and trying the 12 volt barrel plug power supply. Old but true.

A recent power outage had me looking for a battery backup solution for my CPAP machine. Spending $300+ for a CPAP specific solution seemed ludicrous. Enter the FLGAN 20V PD USB-C Power Supply for ResMed AirSense 11, when paired with a proper 65w PD (or greater) power bank, you have portable power for your CPAP at fraction of the cost. Plus you are not restricted to just using your power bank to power your CPAP. I have paired this with a 50,000 mah, 100w PD, power bank and could not be happier. With no changes to climate control I was able to get about 5.5 hours of run time on single charge. If I turned off climate controls (humidity & temp), I was able to get a whopping 8 hours of use and STILL had over 50% charge left. All that for well less than $100. That's what I call a win! It should also be noted that ResMed sells a water tank cap that reduces the size of AirSense 11 considerably and disables humidity control automatically. Pair that with non-clinate sense hose, and you have your AirSense 11 working as a poor man's Air Mini, perfect for camping. I now have two power banks for upto 4 days of off-grid CPAP use or another extra unit to charge a phone.

I have both AS11 and Airmini...these comments are only for the Airmini since, it seems to me, the point of this power supply is portability and that's the Airmini. My goal is ultra-light for airplane flights (long-haul or red-eye) and minimal packing space in my carry-on. I can confirm this cable runs the Airmini using the following wall charger and battery packs:Baseus 30w wall adapter (using only the USB-C output, of course). Runs the Airmini at night and fast-charges phones and battery packs during the day.https://www.amazon.com/gp/product/B09PBVVSW2/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1INIU 45w 15,000 mAh battery.https://www.amazon.com/gp/product/B09GJQG5S3/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1Anker Nano 30w 10,000 mAh battery (A1259).https://www.amazon.com/dp/B0C9CPK4GL?ref=ppx_yo2ov_dt_b_product_details&th=1I was skeptical about the small Anker battery being only 30w output and only 10,000 mAh, but it powered my Airmini for 8 hours and still had over 20% juice left! And that was with EPR ON at Level 3 all night. The Anker Nano is much smaller and lighter than the INIU (which is still a great battery, and really not all that big compared to other larger capacity/power batteries that I just dont need since my goal is small and light). I'm amazed that my CPAP carry-on for a long haul flight is now this FLGAN power supply cable, Anker Nano 30w battery, Airmini with std hose adapter, Q-lite muffler with short hose, in-line HME, and Resmed P-10 nasal pillow mask...all that fits in a small toiletry bag. The longer hoses go in my checked luggage for hotel use, not needed for flights because I no longer have to navigate plugging the Airmini power adapter into a seat plug and hope it works! This little USB power supply cable plus the Airmini is a great combination for me.

Came and Works as expected