OVOVO Power Supply PSU Sleeved Extension Cable with 90 Degree Right Angled PSU Connector Adapter with Combs (4er Pack - 90°, 300mm - White-Black)

These are pretty great, there are some casting marks on the plastic that you may want to touch up with an xacto knife but the only reason I dropped a star is because the braid and cables aren't stiff at all, the cables just flop around which can make getting that clean look your going for (The entire reason to buy these in the first place imo) a bit difficult as the cables fight you and don't want to lay flat. The spacers it comes with are also super loose and just slide up and down the cables freely with gravity.BUT, Once you get then to behave though, they look great!

I really wanted to like this when I saw and it and did. As I installed it for the very first time one of the retaining clips broke for one of the GPU cables. It still works, but you have to be careful not to move anything. I printed up up some cable combs which make it look even nicer, would have been nice if they included some 8x2s out of the box. Contacted the seller for a replacement, but have yet to hear back....

They worked perfectly with the way I wanted to use them. Just make sure you pay attention to which side the lock is on your graphics card. Especially if you're vertically mounting it. I had some regular extensions that were black, gray and white. I grew tired of them and hated the way I had to loop them. Especially the 24pin. This worked great to shoot the cable straight behind the cover.

Even when the cables got a bit misshapen the plastic combs make it really easy to smooth them out. My pc is not fried and posting so they work. The fabric is well woven they feel like solid cables.

I needed a way to make my CPU/8PIN take a 90deg turn away from the motherboard, in fact I need 2 of these so I had to buy 2 kits. Wish they would package these cables so you could just purchase the ones you need. If I could mount my GPU sideways the PCI/8pin cables would be great but I need u-turns there. As for the 24 pin It would make that cable longer than it needed to be so I'm just using a 90degre block turn there. I really wish someone would make just a 90deg adapter for the CPU/8PIN. If I could have used all of the cables or the packaging was made with the 2 CPU/8PIN than I would have given it the full 5 stars.

pretty straight forward, the 90 degree adapter makes the cables lay a lot flatter, making for a cleaner build. highly recommend.

Looks nice and works great

Before I even took it out of the package I saw that one of the pins wasn’t even in the casing. There’s no shot I’m plugging this into my PC.

My original PSU cables were too short for this new NZXT case, and I wanted some that would look good with the rest of the system, and these ones do the job perfectly Routing them is easy, they have a nice cloth braiding over them, and come with cable combs pre-installed. IMO they look very clean and fit the entire computer very well. Just make sure you're ordering the right ones for your PSU, not all connectors are made the same, they're not always interchangeable.

I really love them and they work supper well. They are easy to put in.