Portwest Bizweld FR Coverall, Size: M, Colour: Navy, BIZ1NARM

Very well made and comfortable to wear all day ,welded a quarter panel on a car today and no burns Happy days!

disappointing. the overalls are ok but the bottom of the leg is too small to go over work boots

I'm about 6' tall and a bit chunky round the middle, not the matchstick arms and legs on a broom stick model type, so was looking for a good wide fitting set of overalls. I bought the XXL and they are perfect, legs are long but I can bend over and also reach up high, without becoming a castrato singer.Even after several washes they still fit exactly the same, and all the studs still work. Did manage to rip a few small holes in them, but more my fault than anything wrong with the fabric. Will definitely buy more when needed.

Spot on for size and quality.

After many shots in the dark with sizing, and many pairs that didnt fit, i finally found the perfect pair of overalls. If it helps, i am 5'10" and i havent got a belly !! I think if you have, you may struggle, even with the elasticated sides. As far as quality goes, this is a long established firm. Even though i have worn Dickies FR for many years, I think i may be converted.

Bought these for the small amount of mig welding needed now and again, to keep HSE happy.Seemed fine for a couple small welds, but after cleaning up a small piece of box tube with a grinder they failed completely.I understand that these aren't flame retardant, but to burn a hole though after 10 seconds of grinding is ridiculous. Grinding and welding go hand in hand.Waste of money.

Very durable

Last better than cheaper ones if you use leather welding sleeves I do mostly Spray transfer overhead welding 315 amp flux core 2.2 mm last about six weeks cheap welding overalls only last me 3 weeks if lucky