2 inch Hole Saw with Arbor for Cutting Metal Wood and Plastic, 51mm Bi-Metal Hole Cutter for Different Project with Smooth and Flat Drilling Edge, Fast Chip Removal

Always wanted this size but I couldn’t believe I can get it this cheap, it works well and cut 3/4” plywood like butter and easy to take the extra material off the hole saw, perfect for what I needed for, but I’m not sure how long it will last since I made only two holes for now. Overall easy to work with and cheaper than buying name brands at any store in this size.

I bought this for a single job to install recessed lighting in a tongue and groove pine ceiling, not expecting it to last beyond the job. Boy was I surprised at the quality of it and the price. I cut 12 holes in 3/4" tongue and groove pine and it had 0 issues and still sharp as can be!

Worked perfectly for cutting whole in wood for extractor hose. Great value! Easily attached to cordless power drill So much cheaper than HD/Lowes and did the job great. No complaints

Worked great, went through drywall and a layer of stucco with ease and no damage to the saw .

This hole saw worked great for what I needed. I used it to cut a clean 6-inch hole through the wall of my house to run the vent for my AC, and it handled the job without any problems. It cut smoothly and didn’t bind up like some cheaper hole saws I’ve used before. The arbor held everything securely and the teeth stayed sharp throughout the cut. It worked well on the materials I needed to go through and made the installation much easier than trying to piece the hole together with other tools. If you need to cut a large, clean hole in wood, plastic, or similar materials for things like vents or AC installs, this one does the job well. Definitely happy with it.

I used this 3 3:4” diameter hole saw immediately after receiving it. Quality is excellent and it cuts wood easily and cleanly. Everything comes with it to use in one box. Included is a spare guide drill bit. Of course you use a slow cutting speed with large diameter hole saws and I used this in a drill press. Good price and I recommend it.

I've used a few hole saws before and have been frustrated at how hard it is to get through materials. I've never used one over 4 inches in diameter and was expecting this to struggle getting through the smart siding and OSB sheathing of our house exterior. It tore our house a new one in seconds. It was effortless. I may never have to use it again but it was half the cost of getting one even at harbor freight.

This worked great for me cutting holes in ceiling tiles to install 6" Polk speakers that required an 8 3/16" cutout. I found they worked best when running the drill in reverse to avoid chattering on the mineral fiber tiles.