BACOENG 6.8 L Stainless Steel Vacuum Chamber with Tempered Glass Lid Especially for stabilizing Wood

When I got this, it didn't seem to be leaking but would lose most of its vacuum within 15 minutes - warming the glass+seal in the sun made no difference. The fitting on the side of the pot seemed looser than I would've expected and the gauge/valves moved around freely. The nut on the inside could only be tightened slightly as there was no washer and I didn't want to damage the rubber seal. Adding a steel washer allowed this fitting to be tightened considerably. The whole fitting feels much more rigid and the pot now holds a vacuum for several hours with no discernible change to the pressure inside.

Super quality stainless steel pot with heavy glass lid. Takes full vacuum with no problems time and time again and withstands solvent vapours like alcohol. Holds full vacuum well for at least 24 hours.

This is NOT for resin... sure you can use it for resin before a pour but your just four to add air back into your piecesYou need a pressure chamber for resin where you put your pierce in the pot remove the air and leave it for 24 hours.Watch a YouTube video on degassing v pressure - It says this is for resin and it just isn’t

I first bought this chamber over a year ago to stabilise small batches of knife blocks. I now run 12 chambers using around 2 gallons of resin per cycle in all chambers. I highly recommend these chambers and pump to anyone who is starting out

Brilliant and with the Glass Lid I have had no crazing or cracking. Love the fact the hose connection is on the side of the tank and not through the lid as well.Great bit of kit that’s getting a lot of use 👍👍

Very robust and perfect for my needs

Great little chamber helps me out with my crafting

Have used it 3 times so far. Holds -29inHg vacuum for many hours without any leak.