Under Cabinet Strip Lights Kit 9.8ft/3m, 12V UK Plug Warm White Dimmable LED Strip with Remote, Flexible LED Lighting Strips for Kitchen, Shelf, Cupboard, TV, Desk, Plug in Warm White 2700K

Questa striscia di led è davvero funzionale, l'ho messa in cucina per illuminare la zona buia sotto ai mobili delle credenze e fa il suo ottimo lavoro. Fa una bella luce calda regolabile che alla massima intensità illumina bene. Ovviamente non è un faro, sono adatte a un ambiente limitato, ma io volevo proprio l'effetto luce soffusa. Sono molto sottili e facilissime da applicare. Sembrano le luci di natale infatti ci sono tutte le diverse modalità di illuminazione che hanno le classiche luminarie natalizie. Unica stranezza è che non so perché ogni tanto le luci si accendono da sole e per ovviare a questo ho messo un interruttore per interrompere il passaggio di corrente. Del resto perfette

Top!

facile à installer, belle luminosité, c'est parfait

I’m very happy with these lights – they’re bright, easy to install, and work well once set up. However, I bought two sets for different rooms and ran into an issue that the instructions don’t explain. By default, each remote was controlling both sets of lights. After some trial and error, I discovered that you can pair each remote to a specific light unit so they operate independently. If you’re having the same issue, here’s how to pair a remote to one specific light: How to pair a remote to a specific light: 1) Turn off all the lights at their power sockets. 2) Make sure the light you want to pair has been switched off at the socket for at least 10 seconds. 3) Turn on only the light you want to pair at the power socket. 4) Immediately press and hold the “ON” button on the remote for about 10 seconds. - The light should blink three times at the start of the process. After this, the remote should control only that light. Repeat the same process for additional lights and remotes, making sure only the intended light is powered on during pairing. From what I’ve observed, pressing the “ON” button briefly (without holding it) appears to reset things back to factory settings, which may cause one remote to control all nearby lights again. Hope this helps someone — it would be great if the manufacturer included this in the instructions!

Parfait