Oxford Ultra Clear Anti-Fog Visor Insert.

**UPDATE** 3 months later the glue has come off making it pretty useless, up until then it was perfect. Really disappointed...Read the reviews and was a bit hesitant. My friend who has had a bike for years told me I needed one of these as I don't have a pin lock visor.Yeah the instructions don't seem amazing but that's because is just so simple. Just search on YouTube for fitting instructions. Works amazingly well, I couldn't fog up the insert no matter how hard I tried.My attempt at a during guide below...Take your visor off your helmet, clean it with a baby wipe then dry it with some kitchen role.Take the plastic cover off the visor and pinch the ends so it's almost in half (don't fold it, it should have a curved middle.) Place it in the middle of your visor and let the ends fall, check for positioning and lifts and move if necessary.Smooth down the edges from the middle out, then take of the back cover.Job done!

Actually worked for a short while but if you have pinholes in your visor (for accessories), it lets air behind the insert and it stops functioning.

It was quite easy to fit and it worked pretty well. This is the first product like this I've used so it's hard to know how it compares to other. My problem is that it said in the instructions that it could be washed with soapy water but when I washed my visor the insert came off and left little sticky marks all over the visor, which were quite difficult to get off.

excellent item works great.

It's OK.Very hard to get a good fitting and when it gets dirty from normal use hard to clean so it stays on the visor. But it does keep fog from forming on visor

The adhesive did not stick for long even though I cleaned the visor meticulously. I have had to stick it down with adhesive tape, which is disappointing considering the cost of the item.

Seller on but product rubbish, Oxford should look at the poor adhesive.

Bought this product hoping it would solve a problem1. Instructions very poor, not precise enough especially attempting to take off the protection sleeves of the actual visor.2. First use of this with the helmet on..... no good. Inside gets misted up... what's the point of calling it Anti-fog if it doesn't prevent misting inside ?3. Had to open the visor to clear the mist... while travelling. Obviously your face then gets a freezing blast of cold air. What I didn't expect was that the visor which was supposedly stuck down --- flapped free from one side of the visor.THIS IS DANGEROUS --- I couldn't see for a few seconds until I closed the visor fully down  Oxford Ultra Clear Anti-Fog Visor Insert. -- incidentally it wasn't fully open, only a fraction to let in air to demist the supposedly non-misting visor.4. What a waste of money --- I advise people to use the 'pin' products maybe this will be better than a stick down --- at least get it put in professionally.