2 Pack Universal Racing Seat Slider Track Set

Works great on my racing sim rig. It's quite a bit less than buying from a sim rig company and looks identical. Once adjusted correctly, the seat slides smoothly and locks in place without any play.

Fits perfectly

Bought these to install a seat on a go kart. They are solid but not the highest quality. The biggest issue is that the two parts, fixed and sliding, of each rail set cannot be separated. You have to push each to one end of its travel to put the fastener in the other end, then repeat the other way. There's really only fastener positions at the ends of each part, the fixed and sliding rails. Takes a bit of DIY to fit. And the instructions are almost worthless.

Life saver. Now I can switch positions for different types of racing and my short friends are now able to use my Sim rig lol. The only downside is I wish the adjustments were a little bit smaller from one position to the next is a really big difference, but it still works great

Buy a better seat slider for a few dollars more. The adjustment bar sits on 2 pins and pops off if your rails are too far apart. Led to me moving the rails closer than I wanted on the sim rig. It works, but an unnecessary hassle and wasn’t worth the discount over the TrakRacer variant which locks in place. Hopefully it stays in place now.

Used this for an NRG Prisma on a Sim-Lab P1X. There's zero play in the slider and everything feels rock solid. The slider moves without any binding and easily locks into place. Assembly and installation was easy enough. My only gripe is that the bottom rail is too narrow to fit M8 washers, so I had to do without them (which seems fine). For the installation, I'd suggest that you first get the rails mounted on your rig and aligned properly. Once you're sure that you have the rails distanced properly, remove the seat brackets from your seat and attach the brackets to the sliders. Finally, slide your seat in and secure it to the brackets. This was a lot easier than trying find the correct mounting holes and securing everything with the seat attached. The slider handle hardly needed any adjusting to fit the distance that I needed for my seat, but I can see how it'd be annoying for wider setups. However, the 'bend to fit' approach doesn't seem unique to this slider and you'll need to do the same for many of the other options.

I don’t usually write reviews and when I do they’re usually bad reviews, but these sliders are well built, thick metal, and even hardware is good quality, I was able to fit them on my Sparcos with 0 issues . Don’t OVERPAY!! these sliders are well built .

Quality of the product seems great. It comes with all hardware, which is also great. My 1 star is due to the fact that the item will not fit a Sparco R100, even though it is listed as working for Sparco. I don't know if it fits other models of Sparco race seats but it did not fit the R100.

I installed a set on my dune buggy. The seats were directly bolted to the floor when I purchased the car. The slider seat tracks took some time to attach to the seats and floor. Once mounted they function smoothly and provide the needed room to enter and exit. They can then allow movement of the seat to a comfortable driving position.

Buena compra

I bought two thinking that I'll fit my Recaros but i ended up getting original Recaro sliders so do measure your seat widths.

Great product. Good instructions. Screws were a bit too long but easy to find replacements. Little tough initially sliding but loosens up.

Perfect for your simpit :) I use one of these for my seat in my sim rig and use another for my pedals so that I can slide them back and forth. Works great.