GENUINE Beko Dishwasher Water Inlet Valve 1886740200 DWI644 FDW45 FDW451 ECT

Bought this to replace a leaking inlet valve on our Beko DWD5411Wbwhich had been filling with water and flooding the kitchen floor. Quite a simple repair. Empty the dishwasher and run the start of a cycle to pump out any residual water. Disconnect the power and water. Rurn the mackine on its side and remove the bottom metal plate (4 star head screws) take of the internal water pipe (you will need a pair of pliers to remove the spring clip on the pipe). Remove the grub screw locking the inlet valve in in place.. Turn the inlet valve through 180 degrees and remove. Fit the new valve by following the process in reverse water and reconnect the dishwasher to water and powe and run a quick test cycle to check all is working. Took about 30 mins in total and now working as new. If you can change a plug you can do this and if you need it there are loads of -'how to' guides on u tube.

Did the job

Seller was CutPriceDirect. Quality may be different with other sellers. As with all multi-seller Amazon pages; just because it is the same page, doesn't mean sellers sell the exact same product.This was a perfect replacement for my BEKO DWD5412 dishwasher. My machine was slowly filling with clean water between cycles due the the valve not shutting off the supply correctly. Had to drop machine on its side to remove entire base plate to get to the valve, but the replacement fit in as it should and lined up correctly.So far so good. No more slow fill. If this changes or fails, I will be sure to update.

An original part replacement.Cured the fault.. the machine was slowly filling overnight..

Although it said it was compatible with our dishwasher, it wasn’t exactly the same as the one we replaced - we needed to use a blade to cut it to make it fit which made us a bit dubious as to whether it was the right one. However we now have a working dishwasher! Nice cheap easy fix :)

Works great and was easy to replace, saved us having to buy a new dishwasher.

Replaced my old one which was leaked water in machine causing machine bro STP working as flooding. This is similar part although outlet at different angle.at first thought outlet was too snal but actually fitted well .tip check/mark electronic contacts before fitting as with different angle not possible to see contacts when fitted so won't know which to connect to

Typical; on our Beko dishwasher this value was located at the back, otherwise relatively easy to replace. Take care not to damage the outlet hose, which on the Beko is connected to the same panel at the rear.