USB 3.0 & Type C 3.1 & HDMI Male to Female Car USB C Flush Mount Extension Cable USB 3.0 Dash Mount for Car Truck Boat Motorcycle - 3ft

Fit like a glove and replaced the old usb/headjack on the boat and added some extra features.

I was looking for a port for a computer I’m building in a waterproof box. The computer is a raspberry pi 5. This port keeps all my external wiring neat and there is only one hole in the case on the side.

I bought this based on the dimensions advertised. Per those dims, I planned on it being a direct replacement for the stock cigarette lighter. The unit is much bigger and will not fit in any cigarette lighter hole I've ever seen without enlarging the hole substantially. The thing is huge! Be sure you have a large flat surface with plenty of room behind it before considering this part.Also, the power is reduced considerably by this unit. My phone battery was at 43% battery. When plugged directly into the radio it said 27 minutes until full. When I plugged this unit into the radio then my phone into this unit, it said 6hr 18mins until full.

overall looks/feels like a good product. gave 4 stars because the description says 15/16" diameter. i got ahead of myself and went ahead and plasma cut that size hole. then it gets here and ends up needing a 1 and a 1/2" hole. at least it was bigger and not smaller i guess

Purchased this to pair with my Sony XAV-AX5600. Because the unit has 2 USB pigtails and HDMI input I wanted to get an extension.On the unit it self only 1st USB is designated for AA with 1.5 outage and 2nd USB soly for MEDIA 0.5 outage.I figured I could pair the higher voltage usb with a splitter from this extension to power both my R4 and AA, however it seems it will only do one or the other so I may have to figure out a different method as the 2nd USB doesn't have enough voltage to power the R4.Overall works as expected and look forward to buying again for further projects

Good quality product

First of all, the photos of this adapter don't do a good job portraying its size; this thing is enormous, with the cables connected to it being fairly long but also thick. While on paper this looks like a good fit for installing a Raspberry Pi or similar inside of a case, the cable size alone will make it a bit hard to fit everything in unless your case is larger than you might otherwise expect to be required.More concerning is how tight the fit is for the cables - both inserting a USB device into the ports and inserting the usb cables into the ports of other devices don't feel as smooth as they really should be.Most concerning, though, is that this might be responsible for damaging a USB-C KVM I was testing it with. To test the capabilities of the USB-C, I plugged the USB-C into a full-featured port on a mini-PC I use for testing and the other end into the KVM. All seemed well for a few seconds... but then the PC powered off and I couldn't get any power out of the USB-C port of the KVM (even after removing this extender from the equation and switching to a different mini-PC). Fortunately, it must have just been a self-resetting fuse going off or something since the KVM was working normally again by the next morning, but it's still significant enough that I don't think I will be using the USB-C port on this for anything other than non-negotiated power again (if I use it at all-it's too bulky to fit where I originally bought it to go)

I have a pioneer AVIC W6600NEX with a HDMI jack and USB A Android and USB A Apple. Direct plug to the system and installed in my dash of my ford ranger, seen in picture, works awesome. i use the apple port mostly so i got dust covers in the lesser used port, however they are ready when i need them or have passenger with android. i got an apple lightening to hdmi cable for the hdmi port