Center Console Armrest Add-on Cup Holder for 1999-2001 Dodge Ram 1500 2500 3500 Replaces# SS281AZAA

Love this addition to the center console cup holders are deeper and more stable then the factory ones. Also puts the drinks up where they are easier to get. Only issue is the console lid will not latch but I haven’t messed with it yet

Perfect fit for my 98 Ram 1500 sport with the 5 speed manual.Only negative is it doesn’t fit a soda can, the bottom is tapered for a smaller size, so the can leans, though rise with a can at your own risk with how bumpy there old trucks are.Picture shows in reverse gear without any problems, but it you lift the console while it’s in gear the bottoms of the plastic will hit the stick, same would be if you have a 6 speed when it’s in 6th. If that becomes a problem for me I’ll just cut that plastic there.I used vise grips to turn the catch pin for the lid counter clockwise to raise it enough with the added height from the plastic. I also sunk two screws inside the console just in case the latch comes off while driving and I have drinks in there, I think it would hold but peace of mind.

This is sturdier than I expected! It was very easy to install. It may be the best addition to my Gen2 RAM 1500. It does everything I had hoped. It looks good and it's totally functional.The latch pin was easy to adjust with vice grips, about 5 turns to set it a bit higher to allow the console lid to latch.I expect to buy another for my other RAM 1500 4 by 4.

Fits well. Works as it should. Center console no longer latches with it in. But it stays down without latching.

bought this for my daughters farm truck. very, very easy to install and has been a life savor. very sturdy construction. holds everything, from very large drinks, to having a cell phone slot also. if you need more storage or extra cup holders would recommend this every time.

My armrest doesn’t latch now and it leans forward a little. Not sure if I like it. Looks cheap

Didn’t see a review for a 2008 Cummins with a 6 speed manual, so thought I would add one. It works great. I’ve attached pictures with it in 6th, 4th, and reverse. All clear just fine. Reverse is a little close, but still clears. Install was easy, just had to use some washers to drop the latch down on the console lid. Cup holders work great, but the phone holder isn’t deep enough in my opinion.

Very sturdy insert. Perfectly molded to the innards of the center consul. Doesn’t require any fasteners, but I’m sure it wouldn’t hurt to put a couple screws for added assurance when the lid is open. Had to adjust the stud, so the lid will latch. The material is about 1/8” thick all around. Again, very solid set of cup holders.