SIAMP30992110 1/2" BSP 99T Brass Thread Bottom Inlet Valve - White

Bought this to replace a fairly decent one that had a plastic fitting. It had started to leak (washer had deformed slightly, I think) and in removing it the thread on the plastic fitting got ripped to pieces. Decided to replace it with one with a brass fitting.This one was a good price, but worked very well. It's quiet and simple.

The old one became insanely slow to fill the cistern. This was an inexpensive, good quality, easy to fit, part for part replacement.

Can't fault the seller for this, as any issues I had are really from the manufacturer! Firstly after fitting I had leak, had to refit with my old washer, which had twice the diameter of the one supplied, leak fixed, secondly, it would flush but not refill, had to change the the diagram supplied to my old one, problem solved, think its to do with flow rate? hence I bought this inlet valve because it states, low and high water pressure! Eventually got it working, now 100% but because of the issues only 4 stars, no fault of the seller, it even arrived 6 days before stated delivery date!

Easy to install and positively silent to fill the cistern. Which is a joy after our last noisy, slow one. One slight issue was that the float mechanism wasn’t working at first, and it seemed to stick, which meant it didn’t shut of the inlet valve and water continually drained down into the pan. Anyway, having followed the fitting instructions to the tea, I asked a question to the community and had great support and suggestions. So if you have the same issue- try checking that mechanism isn’t catching anywhere, and has room all around it, secondly lift the float manually and see if the shut of valve works, if it does just give it a bit of a jiggle, and move up and down a few times, it seemed to work for me and just released what ever was catching it. If the shut off valve doesn’t work when you lift it manually, you can assume you have a faulty unit.All else fails ask the community for advise.Goodluck.

A drop-in replacement for an older and faulty one that arrived in a day. Comes simply in a plastic bad with all fittings and a simple manual. Though no paperwork is needed, super easy to fit.Wanted to go with a brass thread to make sure I could undo the connection if needed. It could be a bit trickier with a plastic one once tightened.

Nice piece of equipment... was easy to install and has worked well now without any problems.

It's what i was looking for to replace my old broke one it fit perfectly and work as should now finally I have good pressure and no liking at all

Works perfectly and is very quiet. Straight swap with the existing one, no adjustment required as it filled the cistern perfectly to the full line.