Quick Products QP-HS5839 Bolt-On Receiver Tube - 2", Black

This worked great for what I wanted it for. I used it for a winch mount on my car trailer, so I can remove the winch when not in use. It is very heavy duty. I will buy another one for my other trailers.

Solid Receiver Hitch. I am willing to bet it could handle more than I will ever pull with my heavy duty mower. For the price I definently coulnd’t find anything to complain about. (Wait, online reviews only mattter if you whine and complain right?) Ok then “It is made as you would expect one to be, out of tough enough material to do what it is intended to do and that made it heavy and uncomfortable to pick up off of my porch and carry inside and it was hard to hold up while installing the bolts through it.” I didn’t put a square on it but I also haven’t had an front end alignment done on my mower since the day I got it so maybe I just don’t care about my $7000 mower and honestly I have been too busy cleaning air filters, changing oil and belts, greasing stuff, sharpening blades and cutting grass when I am not busy dragging trash carts, dethatchers and sweepers or moving my boat around the yard with this new super solid receiver hitch that I got for 20 bucks.

Very well built. Good welds and holes equally spaced. Works great on the back of my JD X570 mower. None of the other hitch options I saw would allow use of the JD suitcase weights with the hitch installed. I installed it flush with the rear transmission cover plate, slightly offset to the right using the top oval hole on the mower then drilled the remaining three holes. This provided clearance for the bypass valve lever, two suitcase weights on either side of the hitch and the use of the existing pin hole for my yard cart. The two holes in the receiver for the insert pin is a plus

This is a well made receeiver. Having read the less favorable reviews, I checked it out thoroughly. A 2" hitch goes clear to the bottom of the unit. The tube was reasonably square to the mounting plate. The welds were solid. The mounting holes were not spaced for my JD ZTM, they are wide of the bolt holes in the chassis. I will either drill the frame or add a mounting plate to the receiver. For the price a bit of work will not be s problem. Not a quick easy mount up, but better than the JD 1 3/4" receiver that fits only their hitch and is light duty.

Was able to bolt this on to an engine hoist and fit it on my 1997 Blazer to help lift a bed off of my 99 Dakota to perform some much needed maintenance work, turned a four man job to a two man job

Works for what i needed it for.

Used the receiver tube for a Cub Cadet XT2 lawn tractor and mounted it on the lower portion of the fairly heavy steel lawn bagger mount by drilling four mounting holes. Should be fine for moving a 5X8 cargo and a utility trailer.

Mounted this to the back of my Cat skid steer for pulling a trailer. No problems with hole pattern nor square. The hitch I intend to use fits in nice and smooth. For utility usage and at the low price it is hard to go wrong with this. I would not use this for Highway use since it is not stamped for load. But ones that are DOT rated cost more than twice this. For my needs off road this will work just fine.

غموض النيسان متركب للجبيل شروكي ممكن

Not much to say except it is exactly as shown in the picture. It is very well built. It weighs 7 pounds for those who are weight watchers. Acting as a receiver it will fit all of your items that require a 2 inch receiver

This one is a perfect fit on Lexus Gx 460. Though it is a tad too big.

Good sturdy product well built have put it to a few good tests and no issues at all.

Doesent match with nissan patrol