⚡ Upgrade your engine’s heartbeat with precision and reliability!
The HME301 Hall Effect Sensor is a high-precision, hermetically sealed replacement component compatible with popular European car and motorcycle models. Designed to directly replace Bosch, Siemens, and Honeywell sensors, it offers durable performance with six-inch copper wire leads for easy DIY installation.
R**N
2 x Dead On Arrival - do not swage to plate or thread until you verify they actually switch
Purchased two of these to rebuild an HES plate on a BMW motorcycle. Both arrived DOA. Swapped in a known good plate. I still have no hall effect signal with these replacement sensors. The HME301 provided here has a signal wire that stays high whether vane airgap is interuppted or uninterrupted. The known good HES plate I have switches high when interrupted only and goes low unblocked. I ended up purchasing a new iginition computer because I did not verify that these were good. Still no HES signal to ICU, and both of my ignition computers are good.I have contacted the seller and am awaiting resolution.
O**D
This little part will keep your car from running.
It was exactly as advertised, and it worked. Don't buy a new ignition distributor if all you need is a new Hall Sender.
E**N
Excellent alternative to the original hard to find sensors
Installed two of these on my 1995 BMW r1100 motorcycle. Excellent alternative to the original hard to find sensors. Bike runs perfectly
Trustpilot
1 month ago
3 weeks ago
