SlickMod PreCut Vinyl Smoke Tint for 2021-2022 Jeep Grand Cherokee L Reflector (4. Reflector, 35% Light Smoke)

Very easy to install. I recommend a heat gun/hair dryer. Would be better if it was a tad bit bigger to cover the whole light. Can see a little bit of red on the edges.

Just an low quality vinyl that I didn’t end up using because I could tell it wouldn’t fit. I had to ask for a refund and was refunded less than I paid. Will never purchase from this seller again. Don’t say you allow refunds without disclosing you won’t give a full refund. The returned item was not used nor damaged.

Simple vinyl adhesion (dark see-through sticker). Just gotta be careful and precise. It says to use soapy water and slide it on, etc. I didn't bother with that and it turned out fine on our '22 Grand Cherokee L (with the exception of a FEW bubbles). Overall pleased. A little pricey considering what it is (again, just 2 stickers cut to size).

The outside oval piece over the reflector had curves that didn't match and the center piece didnt cover the top left of its edge. The only pieces that were correct were the simple cuts for the lift door.

Too much cutting off the top and bottom let alone too short to reach all the around. Do not buy