Firecore 3 In SDS Plus Chisel Bit Cranked Angled Bent Chisel for Hammer Drill 42CrMo Tile Removal Tool for Concrete (3" X 6.5") -FS22365

Value for money is great. Worked great for demoing vinyl tiles that were adhered with some insane glue

they work just fine. work better in my smaller chipping hammer. a little short for the bigger hammers. but still work. lasted quite a while before i needed to sharpen. cheap price

I bought 2 of these to remove tile from a church fellowship building. It worked like a top in our 2 Bosch hammers.Great product and have used on other things since. CVT tile, stripped it up great too.

Good value for the money. Bought this with a 5 inch scraper as a combo. The bent angle really helped get below the tile I was breaking up.

I use this bit to help remove some old flooring and the glue that the old floors left behind. I used this alongside a 3 inch bit from Makita which was about $10 more to compare the two. The Firecore bit preformed worse but was still good enough to where I think for smaller projects this would be a perfectly fine option to try out. Most of the difference was not in how well they actually chipped away concrete or glue.To start off the biggest issue with this is how short the shaft is. It means that you have to get much closer to whatever you are working on which makes using the hammer drill for extended periods harder. You do get better precision but if I wanted precision I would want to use a smaller width bit anyway and would want to use this product to chip away large areas. The bit also wore down a bit faster than the Makita bit. It was not a significant difference which means unless you are going through multiple bits the cost of buying additional Firecore bits does not outweigh the cheaper cost however it is something you should note if you are planning to use this on very large projects.Overall the product still worked great, I think for smaller projects this is great cheap option to use however for larger projects it might be worth it to find other options.

Worked perfectly to help remove tile. Great buy esp for the price.

Overall I'm happy with this bit, but it has some flaws. First what I like: It fits my SDS rotary impact driver great. Just need to keep it in "impact only" mode and not rotary. The shape of the head of the bit is great as well. It is sloped in such a way as to make tile removal a breeze. It can easily slip under the tile and stay next to the floor or wall because of the sloped profile. That's my primary use case, so that's a real plus for me. Now what I don't like: This is NOT an industrial or commercial grade bit. The casting has some voids which means that the expected lifespan of this bit is going to be relatively short if you're using it on a daily basis. I would order it again, but not at $15. The quality just isn't there to justify that price.

If you think you’re going to buy the accessory without spending two hours your time, finding the lock nuts and washers they should’ve been installed on it prior to selling it to anyone. You’re sadly mistaken one minute into it all the nuts and bolts that they came with with it, and the extra nuts and bolts they give you fell off that from The vibration of using it fell off, put them back on, tightened them. Same thing fell off. Had to stop what I was doing in the middle after setting everything up and take it to the to the Lowe’s to find locknuts and locking nuts and lockwashers to fix the problem by then it was 9 o’clock at night And couldn’t finish my project so waste of my waste of my time anyway if you buy this it’s it it’s a good product. It does work but the engineering behind it it was flooded without putting a lock nuts and washers on it which would cost them practically probably nothing cost me five bucks and 2 1/2 hours of my time up and back so in beat delayed my project two days, so good luck .