BONTEC Tilting TV Wall Mount for Most 17-86 inch LED OLED LCD Flat Curved Screen TVs, TV Wall Bracket Holds up to 165LBS, Max VESA 600 x400mm

This product was easy to install. Slight tilt, tight to the wall and handles a 65 inch OLED with 300x 300 pattern very secure to the wall. What a value.

It works perfectly just what I needed

The media could not be loaded. The mount is great, the only thing I had an issue with was the screws for the tv, they were a bit too short so I had to buy some in my own. but no big deal. It holds a 75 inch tv easily

It was a great fit

Easy to install

Perfecto ajuste y agarre, resistente, lo usé con un televisor de 65”, adaptable a ambas medidas, 400x400 y 600x400

I have a stud finder so that may be an issue for anyone that doesn't.Studs were 16" so was able to drill and screw into two of them. Makes things easier.TV was a 55" over a bedroom dresser.......Did it myself.......no big deal.Comes with a small level which is accurate. attaches to the top of the wall platemaking it easy to level while you drill and screw the plate into the wall.Comes with a variety of screws/bolts, washers and spacers which in some combinationshould allow you to attach the L/R tv brackets to the back of your tv.Using the same wall mount for a 77' OLEG LG in a couple of days in the living room.I'll be using the 10 degree tilt feature for that installation, Don't need it for the bedroom mount.It's easy to slide the tv after it's mounted to the left or right for a slight adjustment if needed.Don't spend any more for a Wall Mount, this one will do it for you.Have no issue with it being sturdy enough.Update!!Just finished hanging my 77" LG OLED. No Problem at all..........It's in my living room and the center of the TV is 6 1/5' from the floor. I read somewhere that's a recommended height.The 10 degree tilt is just perfect so you get the benefit of being able to view the screen dead on instead of on an angle Brighter picture.........

Most aggravating tv mount I have ever tried to install. First of all the pre-drilled/stamped slots of which there are a few do not line up with 16 inch studs. Let that sink in before you buy this....thix part which mounts on the wall is two piece and way too flimsy to mount to one stud. The additional expansion bolts provided don't work on dry wall so basically this thing in non-functional unless you drill your own holes in it. Again, let that sink in...you cannot use this safely for the larger size tv's it says it's made for without modifying it or getting toggle bolts to use a one stud/drywall combination (which may work but, not my preferred method). Find a different one...there are some reviews besides this one pointing this out...wish I had paid attention to them.