BTF-LIGHTING FCOB COB 10mm 0.39in Connector Kit 14pcs Transparent Connector 5pcs 15cm Long 20AWG Extension Wires for Non-Wired Gapless Solderless,FCOB 2 pin v+ v- Single Color Strip Corner Connection

These worked out great for my under cabinet lighting! Very easy to use, no issues.

Great item…

Used these in a kitchen remodel and provided the perfect lighting feature. Set up can be a bit tricky. But turned out great

They're great when they work but you have no idea if the connection will actually work until you compress them. If the connection fails, then the copper tab on the light strip is ruined and so is that connector. Then you have to shorten your light section and try another copper connection point. Very frustrating!! However, if the connection IS successful, its a huge time saver over soldering and a more reliable connection than soldering. I wish there was a way to verify the connection was good before you compress them but I don't see how that can be possible.

Good pricing

Middle Connectors failed after few days. Before installing the strip on the wall, I have checked the entire strip and worked fine for just few days.

I used the 8mm, 2-connector version to connect COB LED strips from Home Depot. The original Home Depot kit came with a power supply, a lot of wire, including a Y-connector, but by itself was not adequate for a fairly small under-cabinet lighting project, because it didn't provide a way to make connections over short spaces. One issue I had was that I needed to put some of the lights on the bottom of an under-cabinet radio (remember those?), and with the original kit alone it was impossible to do that neatly. With these connectors I was able to cut the original strips *and* the wiring, and make new connections anywhere I needed them. I was even able to cut the pins off the end of the COB strips and insert the short stub with the pins into one of these connectors to make a new male or female pin connector on the end of a wire. The original 20 AWG wire also fitted into the connector, so I didn't need to use the wire that came with the kit - I have that for a future project. I had no problems making the connections - I used needle-nose pliers, so had to come in at an angle, but it probably would have been fine if I'd used a smallish pair of regular flat-end pliers. Every connection worked first time, and I had no damage. It took me a while to figure out which of the many kits available on Amazon was the right one for my project, but I'm very happy with this choice.

Perfect 8mm 2 leads 5VDC.

Made connecting led strip for media wall effortless. Much easier than soldering!!

Se travaille très bien les clips fonctionne bien

El producto es bueno y de calidad pero dicen es de 12 mm cuando es de 10, es la unica queja

No me gustaron ya que si por algun motivo elbseguro no agarra bien el cable y se suelta es muy dificil volverlo a utilizar

Easy to install and very nice lighting.