4 PCS Thickened Coaster Resin Molds, Coaster Silicone Molds for Epoxy Resin, Coaster Molds for Resin Casting, Epoxy Resin Molds for DIY Resin Coasters Bowl mats, Candle Holders, Home Decoration

Needed to cast a memento and these worked well. Good thick wall and still pliable. Separated from the resin easily after cure time. Would recommend for those needing a larger mold.

These silicone molds are great for resin. I would definitely recommend getting them!

I like them, they just aren’t very deep and thin.

Love the size and easy to work with. After using and cleaning it goes right back to the way it look when I bought them. Easy to clean. I recommend.

They are exactly as described and they make a beautiful shiny resin coaster every time.

These molds are good, but the round one was way smaller than it looked in the product photos. It’s too small to be a coaster, so I drilled a hole in it and made it an ornament!I used UV resin for my coasters. If you do this, do it in very thin layers and cure it for a few seconds at a time. Otherwise, it’ll so heat up too much and shrink. I only used this method since I had no Epoxy resin.

Easy to use, easy to clean.

Annoying, I needed a 3.5” diameter coaster… but the actual size is smaller. The mold itself is 3.5, not the coaster that comes out

These were easy to use but after a few uses the side walls have deformed leading to not square sides and also a lot of resin spilled over the sides leading to a big mess.

Good value for the money.

I loved 😍