FERRODAY 0-60 PSI Mini Keg Regulator, Portable CO2 Charger for Keg Growler

Works perfect for my Pinter 2.0 to recharge a flat beer. This past summer, I got creative and made a 10% margarita spritzer by adding CO2 to the pinter and I had fresh margarita spritzers all summer long.

I bought this and a tap, for my 1.5 gallon Torpedo keg. I hate bottling and would rather take a keg with me to share with friends. It doesn't leak, and the pressure lasts longer than the beer does. Good quality and durable, I've been using it for over a year.

Wanted to play with carbonation of some assorted drinks...this seemed the lowest cost way to get into it enough and see if I like it before investing heavily in a tank and fancy regulator. While it says 60PSI the gauge maxes out at 60 and pressure never seems to go above about 50PSI, so be aware if you care about that. I thought it would output 60PSI. But I'm new at this so I don't know if that matters much. I was happy to see it seems like it doesn't just vent uncontrolled when the quick-release is not connected to anything. I did initially overlook the wrench to tighten the adapter fitting into the regulator and had difficulty assembling it until I realized I needed that to get the fitting properly tightened down to be leak-free on the output. We shall see how long these little cartridges last. I don't expect they will last long but it sure is the most portable design I've seen and quite cost-effective for just a quick tinkering or rare/travel use, but if you use it regularly would be expensive buying the little cartridges.

Best threaded regulator I have used. I have been through a few other brands and those have been nothing but a waste of time and money. They either only work for a short bit, need modifications, or just do not work at all. This one does not leak, it's easy to operate (no forcing carts to fit, fiddling w/ Teflon, or fighting the control valve), and has been several dozen carts. Excellent quality for the price.

Junk. The dial stop worked once then the dial cones completely out. Could be dangerous. Avoid and buy better brand.

Each CO2 cartridge seems to be enough to serve about 2.5 gallons of an already carbonated beer. I made sure the keg already had about 12psi of head pressure on top of the pre-carbed beer. I then followed the instructions by decreasing the flow on this CO2 unit all the way to the minimum, attaching a food grade CO2 cartridge and then slowly opening the flow to the point it would maintain 10-12 PSI.

This is the perfect addition to keep my keg carbonated on the road. I do not use it to carbonate my beverages. I only use it to keep the carbonation while traveling.

Excelente

Bin sehr zufrieden. Funktioniert super und tut genau was es soll 👍